Audio Video) Connection - Sanyo CZP3045 Operating Instructions Manual

Tuning
Tuning Indicator @—,
Band Switch
Tuning Control
@Tuning Indicator
Imu
'& Bandl VliFChannel l., . . ...3
'@ Bandlll V!-lFChanne14 . . . . . ..ll
'~ Band UUHFChanne121 . . . ...69
Figure-2
Figure-3
..
Tuning
1.
2.
3.
4.
5,
Refer to Figure-2.
Press either +or —programme selector button ~
, step by step, until the desired number is
displayed intheprogramme indicator CJ
Reset the band switch ~
to the position corresponding to the channel to be switched over
Figure-3 .Theband switch can beeasilyturned byusingtheadaptor knob @ which islocatedw
the control box.
Turn thetuningcontrOl "~ corresponding to the chosen programme number until the desired
channel is indicated by tuning indicator @ Read the band 1, Ill, orU scale on the indicator
corresDondina to the band switch. The tuning COntrOl should becarefully adjusted for the best
sound'and pi;ture onthe desired channel. -
Repeat the procedure for other programme numbers if required.
After presetting the required programmed, close the control box.
A.V. (Audio Video) Connection
To use the set with a video cassette recorder the set must first be tuned to the channel signal Produced
by the VCR. Connect and operate the VCR according to the Manufacturers instructions. Select
programme"8 (AV)" and rotate the adjacent tuning control until the set is tuned into the recorder signal.
For future use it will only be necessary to select programme"6
(AV)".
3