Table of Contents
Advertisement
It is the responsibility of the equipment owner to
perform a personal protective equipment hazard
assessment to ensure adequate protection during
maintenance procedures.
Failure to disconnect the power at the main power supply
disconnect could result in serious injury or death. The
power switch DOES NOT disconnect all incoming power.
Cords on DIS models used as drop-ins into a counter or
into another piece of equipment are directly connected
to the power source. On CAB units there is a cord from
each individual DIS tube to a central receptacle on the
cart and a separate cord from that receptacle to the
main power source.
Disconnect electric power at the main power disconnect
for all equipment being serviced. Observe correct
polarity of incoming line voltage. Incorrect polarity can
lead to erratic operation.
n
When using cleaning fluids or chemicals, rubber gloves
and eye protection (and/or face shield) must be worn.
Part Number: 9291468 07/16
Maintenance
DANGER
DANGER
DANGER
Warning
Section 4
When cleaning the unit, care should be taken to avoid
the front power switch and the rear power cord. Keep
water and/or cleaning solutions away from these parts.
Never use a high-pressure water jet for cleaning or
hose down or flood the units with water. Do not use
power cleaning equipment, steel wool, scrapers or wire
brushes on stainless steel or painted surfaces.
Heated units must be allowed to cool down before
cleaning.
Never use an acid based cleaning solution! Many food
products have an acidic content, which can deteriorate
the finish. Be sure to clean the stainless steel surfaces of
ALL food products.
Maintenance and servicing work other than cleaning as
described in this manual must be done by an authorized
service personnel.
Warning
n
Warning
n
Warning
n
Caution
,
Caution
,
19
Advertisement
Table of Contents
