Cable Assembly - Sears 831.159370 User Manual

16. Lubricate both axles (A) on the Top Frame (55).
Slide the Right Arm (48) onto the right axle. Note: Be
careful not to confuse the Right and Left Arm.
Make sure the upper end of the Right Arm is
behind the indicated bracket (B) on the Top
Frame.
Tap two 1" Retainers (69) and a 1" Round Cover Cap
(70) onto the right axle.
Make sure the teeth on the Retainers (69) bend
toward the Cover Cap (70), as shown in the inset
drawing.
Attach the Left Arm (47) in the same manner.
Press a 1 3/4" Square Inner Cap (44) into the lower
end of each Arm (47) and (48).
Wet the lower end of each Arm with soapy water.
Slide a 10" Pad (45) onto the lower end of each Arm.
17. Refer to the inset drawing. Attach the Bumper (82) to
the Press Seat Frame (77) with the 1" Tap Screw (92).
Press a 2" Square Inner Cap (27) into each end of
the Leg Press Arm (89).
Lubricate the 3/8" x 3 1/4" Bolt (85). Attach the Leg
Press Arm (89) to the Press Base (51) with the Bolt
and a 3/8" Nylon Locknut (21).

Cable Assembly

18. Locate and open the parts bag labeled "Cable
Assembly and Pulleys." For Cable identification
and routing during steps 18-35, refer to the Cable
Diagram and Cable ID Chart on page 19.
Tighten the Bolt and Locknut on the pre-assembled
Pulley (15) on the Top Frame (55)
Attach a "V"-Pulley (6) and a Long Cable Trap (50) to
the indicated bracket (A) on the Butterfly Upright (42)
with a 3/8" x 2 1/2" Bolt (7) and a 3/8" Nylon Locknut
(21). Make sure the Long Cable Trap is positioned
as shown, so it will hold the Cable in place.
16
A
48
45
17
89
27
21
85 Lubricate
27
18
55
15
42
10
55
B
69
70
44
69
92
82
77
77
51
50
6
A
21
47
Axle
70
7