Assembly - Sears 831.285780 User Manual

ASSEMBLY

Assembly requires two people. Place all parts of the stepper in a cleared area and remove the packing materials.
Do not dispose of the packing materials until assembly is completed. Read each step carefully before beginning.
THE FOLLOWING TOOLS ARE REQUIRED FOR ASSEMBLY: The included allen wrench
screwdriver
1. Feed the end of the console wire harness down through the
Upright (2). Attach the Console (50) to the Upright with four #8
x 1/2Ó Screws (25). Be careful to avoid pinching the
console wire harness.
2. Remove the five indicated #8 x 1/2Ó Screws (25) from the
Right Side Shield (55). Remove the five corresponding #8 x
1/2Ó Screws from the Left Side Shield (62). Do not remove
the Side Shields.
3. While another person holds the Upright (2), connect the
console wire harness to the Lower Wire Harness (32). Refer to
the inset drawing. If the Wire Harnesses do not fit together
easily, turn themÑdo not force them together.
Tip the Side Shields (55, 62) forward. If the three M10x 25mm
Button Screws (49) and M10 Lock Washers (20) are in the
Frame (1), remove them. Feed the Wire Harness (32) into the
Frame, and slide the Upright (2) onto the Frame. Loosely
thread the three M10 x 25mm Button Screws with M10 Lock
Washers into the Upright and the Frame. After you have
threaded all three Button Screws into the Upright and the
Frame, firmly tighten them.
Tip the Side Shields (55, 62) back and reattach them with the
ten #8 x 1/2Ó Screws (25) removed in step 2. Install the bottom
4
Screws first.
, and a rubber mallet .
1
50
2
2
62
3
2
49
20
Console
Wire Harness
32
1
, a phillips
25
Console
Wire Harness
55
25
25
20
49
55, 62