Service Guide SP-i160 Table of Contents Revision History …………………………………………………………………….2 Table of Contents ……………….……………………………………………………3 Getting Started ……………………………………………………………………….4 Conventions Used in this Guide ……………………….…..………………..4 Safety Precautions …….……………………………………………………..4 Chapter 1. How to Handle Defective Returns……………………………………..5 1.1 Overview …………………………………………………………..5 1.2 Problems …………………………………………………………...6 1.2.1 No sound (Line in jack no function) …………..…7 1.2.2 Power LED (indicator) no light……...………..…8...
Service Guide SP-i160 Getting Started Conventions Used in this Guide Pay Special Attention : Instructions that are important to remember and may prevent mistakes . Caution : Information that, if not followed, may result in damage to the product .
Service Guide SP-i160 Chapter 1. How to Handle Defective Returns 1.1 Overview Receiving Defective speakers from Customers Function NG __ __ Analyzing possible malfunction causes Deciding & proceeding the Function NG rectification methods Function OK Replace necessary defective parts Function OK...
Service Guide SP-i160 1.2 Problems Item Problem Description 1.2.1 No sound (Line in jack no function) 1.2.2 Power LED (indicator) no light 1.2.3 Li-ION battery can’t charge Version : 1.0 Page 6 of 14...
Page 7
Service Guide SP-i160 Attention Please follow the numbered sequence marked within parenthesis given in individual Flow chat, in that this is the best-recommended sequence to rectify the problems. 1.2.1 One or more channels no sound (Line in jack no function)
Page 8
Service Guide SP-i160 1.2.2 Power LED (indicator) no light Power LED (indicator) no light Problem Defective Power switch or LED Analyzer and defective Identify the Causes Re-solder or replace defective component(s) Solutions 1.2.3 The Li-ION Battery can’t charge The Li-ION battery can’t...
Service Guide SP-i160 Chapter 7. Important Notes 7.1 Packing Requirement for Sending the PCB Assembly by Post PCB assembly is a kind of sophisticated electronic circuit board. Well packing will be required when sending them by post. * Some sophisticated IC components are mounted on the PCB assembly, hence it is necessary to pack each PCB assembly with a separate static protecting bag, in order to avoid static electricity.