Philips BT5200/15 Manual page 27

Problem
The
appliance
does not
work
when it is
switched on.
BT5200-15EN_A6_CS6_new.indd 26
12 Break the 3 snap hooks on both sides.
2
1
13 Remove the motor unit from the appliance and
remove the battery.
- If necessary, cut the wires to separate the printed
circuit board and the rechargeable battery.
Guarantee and support
If you need information or support, please visit the
Philips website at www.philips.com/support or
read the worldwide guarantee leaflet.
Troubleshooting
This chapter summarises the most common
problems you could encounter with the appliance.
If you are unable to solve the problem with the
information below, visit www.philips.com/
support for a list of frequently asked questions or
contact the Consumer Care Centre in your country.
Possible cause
The battery is
empty.
Solution
Charge the appliance fully (see chapter
'Charging'). It takes approximately 60
minutes to charge the appliance fully.
You can also operate the appliance
from the mains.
26
ENGLISH
15/05/26 20:43