Aironet 4800 Series Technical User Manual page 45

Table 2.12 - PC Card Keywords
Keywords
PORTBASE
PORT
INT
IRQ
SOCKET
MEMORY
MEM
Drivers for Special Installations
Value
0 – 0xFFFF Optional – specifies the starting
address for a block of 64 consecu-
tive 16-bit I/O ports. Make sure the
block of I/O addresses does not
overlap the address of another
device in the machine. This can be
used to override a card service
assignment. If card services are not
used, this will default to 0x140.
Only valid in NET.CFG file (same as
PORTBASE).
2-15 Optional – specifies the hardware
interrupt the PC Card will use. The
Interrupt must be unique (i.e. not
used by another device in the
machine). This can be used to over-
ride a card service assignment. If
card services are not used, this will
default to 11.
Same as INT.
0-7 Optional – If card services are used,
this keyword is ignored. If card ser-
vices are not used, this is the PC
Card socket the PC Card is inserted
into (default is 0).
0xC000 – Optional – If card services are used,
0xDF00 this keyword is ignored. If card ser-
vices are not used, this is a block of
memory the driver will use to view
the PC Card CIS (default is
0xD000). In the NET.CFG file the
parameter is D0000, not 0xD000.
Same as MEMORY.
39
Description