Care And Maintenance; Bulb Replacement - Health Zenith DualBrite 4700 Installation And Operating Instructions Manual

• Manual Mode – Manual mode overrides the motion sen-
sor and "DUALBRITE" control so the light will operate
full bright. This feature only works at night and only for
one night at a time. The motion sensor will reset to motion
sensing mode after 6 hours or sunrise, whichever comes
first. Manual mode can be toggled on and off using a wall
switch. Note: If the power to the light fixture is off for
more than 5 seconds, allow the motion sensor to warm
up prior to switching to manual mode.
1. Ensure the power to the light is ON and the sensor
has warmed up (90 seconds).
2. To turn manual mode on after dark, switch the power
OFF–ON–OFF–ON at the wall switch within 5 sec-
onds.
3. To turn manual mode off, switch the power OFF–ON–
OFF–ON at the wall switch within 5 seconds.
OFF ON
Less than 5 seconds
IMPORTANT: If manual mode does not turn ON or OFF,
use a slower pace turning the power ON and OFF at the
wall switch while staying within 5 seconds.
209819-01
OFF ON

CARE AND MAINTENANCE

• To prolong the original appearance, clean with clear water
and a soft damp cloth only.
• Do not use paints, solvents, or other chemicals on this
light fixture. They could cause a premature deterioration
of the finish. This is not a defect in the finish and will not
be covered by the warranty.
• Do not spray with hose or power washer.

BULB REPLACEMENT

1. While holding the globe assembly with one hand,
remove the two decorative screws on top of fixture cap
with the other.
2. Replace bulb (tungsten incandescent, medium base,
type "A", 100 watt maximum).
4. Replace globe assembly onto fixture.
5. Secure with decorative screws.
Decorative Screw
Fixture Cap
Globe
Assembly
7