Disposing Of The Appliance; Displayed Messages - DeLonghi ECAM23.46X Instructions For Use Manual

This product complies with European regulation no.
1935/2004 on materials and articles intended to come
into contact with food.

19. DISPLAYED MESSAGES

DISPLAYED MESSAGE
FILL TANK
EMPTY GROUNDS CONTAINER The grounds container (A15) is full.
INSERT GROUNDS CONTAINER After cleaning, the grounds container has not
ADD PRE-GROUND COFFEE
GROUND TOO FINE ADJUST
MILL
DESCALE
LESS COFFEE
POSSIBLE CAUSE
Insufficient water in the tank (A10).
been replaced (A15).
The "pre-ground coffee" function has been se-
lected without placing any pre-ground coffee
in the funnel (A6).
The grinding is too fine and the coffee is deliv-
ered too slowly or not at all.
If the water softener filter (C4) is present, an
air bubble may have been released inside the
circuit, obstructing delivery.
The machine must be descaled.
Too much coffee has been used.

18. DISPOSING OF THE APPLIANCE

The appliance must not be disposed of with house-
hold waste, but taken to an authorised waste separa-
tion and recycling centre.
REMEDY
Fill the tank with water and/or insert it correct-
ly, pushing it as far as it will go until it clicks
into place (fig. 3).
Empty the grounds container and drip tray
(A19), clean and replace (fig. 25). Important:
when removing the drip tray, the grounds con-
tainer must be emptied, even if it contains few
grounds. If this is not done, when you make
the next coffees, the grounds container may fill
up more than expected and clog the machine.
Remove the drip tray (A19) and insert the
grounds container.
Place pre-ground coffee in the funnel (fig. 12)
or deselect the "pre-ground" function.
Repeat coffee delivery and turn the grind-
ing adjustment dial (A2) (fig. 11) one click
clockwise towards 7 while the coffee mill is
in operation. If after making at least 2 coffees
delivery is still too slow, repeat the correction
procedure, turning the grinding adjustment
dial another click until delivery is correct (see
section "10.4 Adjusting the coffee mill"). If the
problem persists, make sure the water tank
(A10) is fully inserted.
Insert the hot water spout in the appliance and
deliver a little water until the flow becomes
regular.
The descaling procedure described in section
"14. Descaling" needs to be performed.
Select a milder taste by pressing the dial
pre-ground coffee.
21
(B6) (fig. 8) or reduce the quantity of