Operation - vitapur VWD1076BLST Use & Care Manual

TOUCH SENSITIVE ELECTRONIC CONTROL PANEL FUNCTIONS
Note: Lightly touch the controls. DO NOT PUSH.
4
COLD WATER
1
ACTIVATION BUTTON
CHILD SAFETY
2
LOCK BUTTON
HOT WATER
ACTIVATION BUTTON
3
HOT WATER HEATING
ACTIVATION BUTTON
4
LED EMPTY WATER
5
BOTTLE WARNING
LED HALO LIGHTS
6
WARNING: Hot water temperatures can reach 94C/201F and produce severe scalding, never let
children dispense water without direct adult supervision.

Operation

1. DISPENSING ROOM AND COLD WATER
2. ADJUSTING THE TEMPERATURE (COLD WATER ONLY)
NOTICE: This model Water Dispenser left the factory with the cold
water temperature control factory "default setting" positioned for
"Energy Star" compliance (identified to the side). This setting will
deliver cold water temperatures between 8°C ~ 10°C (46.4°F ~
50°F) The cold water temperature can be adjusted, (using a flat
screwdriver) by rotating the adjustment screw clockwise or anti-
clockwise between "Min" (cool) and "Max" (colder) until the desired
temperature is reached. NOTE: Any change/adjustment to the cold
water temperature control may effect Energy Star efficiency.
3
Touch and keep your finger on the cold water control (#1) until the desired
amount of cold water is dispensed.
Child safety lock #2 must be activated, (unlocked) each time you draw
hot water only. Touch the button, (1 second) wait for the beep, you have 5
seconds to activate the hot water control before it automatically re-locks.
Touch the child safety lock control #2, wait for the beep and release (LED
light will flash), you have 5 seconds to touch/activate the hot water control
#3 (flashing LED = unlocked). Touch and keep your finger on the hot water
control until the desired amount of water is dispensed.
You do not have to activate the child safety lock to initiate the hot water
heating function, simply touch the hot water heating control #4 and wait
for the beep, the LED halo light #6 will start flashing. Heating cycle takes
approximately 3 minutes. When the halo light stops flashing, 4 beeps will
sound and the heating cycle is complete, the hot water is now ready.
When the LED light in the center of the water bottle icon starts flashing, the
water bottle is empty. Replace the water bottle.
The halo lights surrounding the cold water control #1 and hot water control
#4 will only start to flash during the heating and cooling cycles.
1
1
5 6
Note: Room temperature water is only
available when the hot water heating
system is not being used.
2
2
2 1
3
3
ENERGY STAR FACTORY
DEFAULT SETTING
TEMP
Min
Min.
Max
Max.