Table of Contents
Advertisement
References
Trouble Checks
You may have problems
that can be fixed with a few mino_ adjustments.
Look for the type of problem
you are having below and then try the
suggestions
to get your TV going again.
Trouble
Power
TV will not turn on
No picture, no sound but
TV has power
Checks
and Adjustments
Plug TV in.
Plug something
else into the outlet to make sure it is working.
Make sure batteries
in the remote are not dead.
Aim the remote at the TV and press TV.
Make sure batteries
are placed in the remote the right way.
See batteries
on page 2.
Unplug
TV for a few minutes
and then turn it on again.
Check antenna
connections.
Check position
of Cable/Air
feature.
See page 24.
Try another
channel.
Inactive channel may be tuned.
Make sure component
connected
to the VIDEO INPUT jacks is turned
on
if you choose channel 00.
Make sure TV is tuned to the same channel as the switch on back of VCR
if watching
a VCR.
Make sure TV/VCR
button on VCR is in correct position when using VCR.
Remote
Buttons don't work when
you press them
Works part or none of the
time
Press TV to set the remote to control the TV. See buttons on page 6-7.
Clear the path between
the remote and TV of any objects.
Aim the remote at the component
you are trying to control.
Press TV so remote will control TV.
Make sure batteries
in the remote are not dead.
See if batteries
are placed in remote
correctly.
See batteries, page 2.
Can't select certain channel
Press number
buttons.
Channel
may not be in memory.
See Autoprogram
on page 19.
Make sure TV/VCR
switch on VCR is in the TV position.
For numbers
over 100, press and hold 1 until 1-- appears,
then press the
other two numbers.
Set Cable/Air
feature to Cable for channels higher than 69. See page 24.
Remote Lockup
Remove batteries
and hold down one or more buttons
for several seconds
to drain the microprocessor
inside the remote and reset it. Re-install the
batteries
and try remote again.
27
Advertisement
Table of Contents
