Product Specifications; Intended Use - Bosch GEX 150 TURBO Operating Instructions Manual

Product Specifications

Eccentric Sander
Order number
Rated input power
No-load speed
Stroke rate at no load
Sanding plate speed
for operating mode 1
Speed selection
Eccentricity
Sanding plate dia.
Weight without mains
cable approx.
Protection class
Please observe the order number of your machine.
The trade names of the individual machines may vary.
Noise/Vibration Information
Measured values determined according to EN 50 144.
The A-weighted sound pressure level of the product is
typically 81 dB(A). The noise level when working can
exceed 85 dB(A).
Wear ear protection!
The typical hand-arm vibration is below 2.5 m/s
Product Elements
1 Speed selector thumbwheel
2 Screw for attaching the vacuuming adapter
3 On/off switch
4 Vacuuming adapter
5 Auxiliary Handle*
6 Sanding sheet*
7 L-type Allen key*
8 Screw for attaching the sanding plate
9 Sanding plate
10 Sealing collar
11 Operating mode switch
12 Unlocking button
13 Threaded hole
* Not all the accessories illustrated or described are in-
cluded in standard delivery.
2 609 932 151 • (03.03) T
GEX 150 TURBO
0 601 250 7..
[W] 600
[RPM] 3100–6650
[RPM] 6200–13300
[RPM] 290–620
q
[mm] 4,5
[mm] 150
[kg] 2.4
/ II

Intended Use

The machine is intended for dry sanding of wood,
plastic, metal and filler material as well as painted sur-
faces.
Machines with electronic control are also suitable for
polishing.
If the cable is damaged or cut through while work-
s
ing, do not touch the cable but immediately pull the
mains plug. Never use the machine with a dam-
aged cable.
Connect machines that are used in the open via a
s
residual current device (RCD) with an actuating
current of 30 mA maximum. Do not operate the
machine in rain or moisture.
Wear safety glasses.
s
Safety gloves are recommended.
s
2
.
Always direct the cable to the rear away from the
s
machine.
Secure the workpiece. A workpiece clamped
s
with clamping devices or in a vice is held more se-
cure than by hand.
The machine can be used only for dry sanding.
s
Working with material containing asbestos is not
s
permitted.
Always hold the machine firmly when working and
s
provide for a secure stance.
When sanding metal, flying sparks are produced.
s
Take care that no persons are endangered. Be-
cause of the danger of fire, no combustible materi-
als should be located in the vicinity (spark flying
zone).
Always switch the machine off and wait until it has
s
come to a standstill before placing it down.
Never allow children to use the machine.
s
Bosch is able to ensure flawless functioning of the
s
machine only if the original accessories intended
for it are used.
English–1
For Your Safety
Working safely with this machine is
possible only when the operating
and safety information are read
completely and the instructions
contained therein are strictly fol-
lowed.
In addition, the general safety
notes in the enclosed booklet must
be observed.