Advertisement
ATTENTION:
Instructions, notices and wiring diagrams included in this
insert supersede those included in main instruction booklet.
Part number 46115-VUH (Solenoid Heater Control Valve) has been
replaced by part number 461171 (Servo Heater Control Valve). Please
see illustration below for installation and flow direction. See wiring
diagrams on Pages 3 and 4 of this insert for proper wiring connections.
NOTE:
A. Wiring harness modification is required to install this valve.
Follow the wiring harness modification instructions on
Pages 5 and 6 of this insert.
B. Flow direction follows molded arrow on valve.
C. Connection between heater control valve and wiring adapter
may be located in engine bay or passenger compartment. Be
sure to secure ground ring terminal to chassis ground.
Heater
Hose
Wiring Adapter
Hose Clamps
From Heater
Control Valve
to Heater Core
907173 REV A 5/14/14, PG 1 OF 6
Ground
Ring
Terminal
Advertisement
Table of Contents
Related Manuals for Vintage Air 46115-VUH
Summary of Contents for Vintage Air 46115-VUH
- Page 1 Instructions, notices and wiring diagrams included in this insert supersede those included in main instruction booklet. Part number 46115-VUH (Solenoid Heater Control Valve) has been replaced by part number 461171 (Servo Heater Control Valve). Please see illustration below for installation and flow direction. See wiring diagrams on Pages 3 and 4 of this insert for proper wiring connections.
- Page 2 Vintage Air strives to harden our products against these types of electrical noise, but there is a point where a vehicle’s electrical system can be degraded so much that nothing can help.
- Page 3 Wiring Diagram www.vintageair.com 232007-VUR AC ANNUNCIATOR BACKLIGHT POS BACKLIGHT NEG 5V-SW WHT/RED TEMP WIPER WHT/YEL MODE WIPER WHT/GRN FAN WIPER PRE-WIRED VIEWED FROM WIRE SIDE GEN IV ECU 232002-VUA GEN IV WIRING DIAGRAM (IF USED) REV D, 5/6/2014 TEMP MODE PROGRAM * DASH LAMP (IF USED)
- Page 4 HARNESS TERMINAL) HARNESS ARE NOT IGNITION USED. Dash Light: YELLOW SWITCH ORANGE Tan Wire Used Only With Vintage Air Supplied Control Panel With LED Back DASH BACK LIGHT+0-12v Light. GRAY GRAY WIRE IS USED FOR PROGRAMING CONTROLS IF APPLICABLE GREEN...
- Page 5 Wiring Harness Modification www.vintageair.com IMPORTANT: Disconnect the wiring harness red lead from the positive battery terminal. Disconnect the heater control valve relay from the Gen IV wiring harness. NOTE: The heater control valve relay is connected to (2) red wires and (2) green wires. The compressor relay is connected to (2) blue wires. Do NOT disconnect the compressor relay.
- Page 6 Wiring Harness Modification (Cont.) www.vintageair.com Insert one of the (2) red wires into Position “1” of the new (white) heater control valve connector. Push the terminal inward until it locks into place. NOTE: It does not matter which of the two red wires is used for this step. Insert the remaining red wire into Position “2”...
Need help?
Do you have a question about the 46115-VUH and is the answer not in the manual?
Questions and answers