Advertisement
DOING LAUNDRY IN A COMBO
•
Don't let laundry pile up. Keep up with
laundry by doing a small load every
day or two. Make it part of your routine
to throw a load in after your workout or
before you go to bed and let your Splen-
dide do the rest!
•
Because your washer-dryer is front-
loading and operates on 110V, cycle
times may be longer than what you're
used to: 40 to 80 minutes to wash. 90 to
110 minutes to dry.
•
Your washer-dryer is extremely effi cient.
You might not be able to see water in
the drum during wash. This is normal.
•
Once set, the Dry Time, Water Temp,
and Cycle knobs WILL NOT move.
The 'Status LED's' will let you know the
progress of your cycle.
•
Always use fabric softener for
WASH-TO-DRY LOADS. Using softener
assures that the laundry falls easily from
the drum after high spin and tumbles
freely during the dry cycle.
SPECIAL WINTERIZATION INSTRUCTIONS FOR RV/MARINE INSTALLATIONS :
To winterize your
washer-dryer,
1.
With washer-dryer power
OFF, pour ½ quart of RV-type
antifreeze into washer drum;
2.
Close door. Advance Cycle
Selector to 'Spin';
3.
Press ON/OFF button, then
press START. let the washer-
dryer run for 1 to 2 minutes;
4.
Press ON/OFF button to turn
power OFF.
5.
Unplug washer-dryer
from electrical outlet (or
disconnect power);
6.
Turn water supply faucets
OFF. Disconnect inlet hoses
from faucets;
7.
Drain remaining water from
the hoses. FINISHED.
www.splendide.com
COMBO WASHER-DRYER LAUNDRY TIPS
FOR BEST RESULTS,
•
NEVER OVERLOAD THE DRUM.
•
NEVER EXCEED the recommended
detergent and softener amounts.
•
USE FABRIC SOFTENER, or a
detergent with built-in softeners.
•
NEVER OVERDRY LAUNDRY. Moisture
is what makes fabrics soft and fl uffy.
•
Use 'Cotton Heavy Duty' cycles ONLY for
heavy cottons (towels, jeans, etc.)
•
For items that may wrinkle, use 'LOW
SPIN' in wash and/or 'LOW HEAT' with
'Synthetics Dry.'
•
For mixed loads, remove items that may
wrinkle while still damp (dress shirts,
etc.) Hand press and hang them. Then,
continue drying the rest of the load
(underwear, towels, etc.)
•
After washing, shake out LARGE ITEMS
(pants, sheets, etc.) Loosely fold them
and place them back in the drum. Then
dry them. This will improve drying times
and reduce fabric wrinkling.
To use your
washer-dryer again,
1.
Reconnect water inlet hoses
to corresponding HOT/COLD
faucets. Turn faucets ON.
NOTE: Check water inlet hoses
and pump periodically (see
Users Guide);
2.
Plug washer-dryer into
appropriate electrical outlet
(see Users Guide) - OR
reconnect power supply;
3.
With washer-dryer power OFF,
pour 1/2 TBSP. of powder
detergent (or liquid equiv.)
into compartment '2' inside
Dispenser Drawer ;
4.
Advance Cycle Selector to
position '9';
5.
Press ON/OFF button, then
press START.
6.
Allow machine to run through
the complete cycle to clean
out any remaining antifreeze.
FINISHED.
I M P O R T A N T ! D O N O T D I S C A R D !
Keep this page with your owners manual for future reference
WHERE'S THE LINT FILTER?
Your washer-dryer is so gentle on
fabrics, that very little lint is produced.
It passes safely through a special,
'self-cleaning' pump system and then
out the drain and/or dryer vent of
your washer-dryer. There's no fi lter
for you to clean!
However, if your washer-dryer
is vented (Model 2100XC), it's
recommended that you occasionally,
go outside and check the dryer vent
for proper airfl ow. Assure that the
vent and ducting are lint-free.
ABOUT VENTLESS DRYING
If your washer-dryer is ventless,
(Model 7100XC) , when you remove
items after the self-condensing
drying process, they may feel slightly
damp. THIS IS NORMAL. Simply
shake items out to allow any steam
to dissipate (a few seconds) before
folding or hanging them as you
usually would. NOTE: Splendide's
self-condensing drying process
will not add heat or humidity to the
surrounding area.
Optional Winterization
instructions
If you're currently pumping
antifreeze through your fresh water
system, you can follow these steps
to winterize your washer-dryer:
1.
With machine power OFF, turn
WASH TEMP knob to 'HOT';
Advance Cycle Selector to
2.
position '3';
3.
Press ON/OFF button, then
press START. Let machine fi ll
until the drum turns (could take
up to 1 to 2 minutes);
4.
Press ON/OFF button to turn
power OFF;
5.
Advance Cycle Selector to
'Spin';
6.
Press ON/OFF button, then
press START.
7.
After letting antifreeze drain
completely from drum, press
the ON/OFF button to turn
power OFF. FINISHED.
Advertisement
