Seagate BARRACUDA 4LP ST32171N/W/WC/WD/DC Installation Manual page 44

42
W/WD drives
Terminating the drive
"W" model drives are terminated with permanently mounted IC
active terminators. If you install one of these drives and it is not
on the end of the SCSI bus, disable the terminators by removing
the jumper "TE" from pins 15 and 16 of connector J2. If you
install the drive on the end of the SCSI bus, enable termination
by installing a jumper on pins 15 and 16 of connector J2 (see
Figure 13).
Note. Use active (ANSI SCSI-2 Alternative 2) terminators when
terminating the bus.
"WD" model drives do not have internal terminators or any other
way of adding internal termination to the drive. You must provide
external differential termination to these drives when termination
is required.
*Enable SCSI terminator
*Disable SCSI terminator
*"W" model only
J2 Jumper Type
(enlarged to
show detail)
Figure 13. Terminating the drive ("W" model shown)
Barracuda 4LP Installation Guide, Rev. B
J2
T D
E S
J6
Drive
Front
Pin 1
R
M W P E T T
E P D S P P
(default)
J2
SCSI I/O
J1
Connector
DC Power
Connector