OCENCO M-20.2 Instruction Manual

OCENCO M-20.2 Instruction Manual

Self-contained self-rescuer emergency escape breathing device
Hide thumbs Also See for M-20.2:

Advertisement

OCENCO M-20.2
Self-Contained Self-Rescuer
Emergency Escape Breathing Device
INSTRUCTION MANUAL
Manual No: NH22050
Revision F, ECN 2760
Page 1 of 16

Advertisement

Table of Contents
loading

Summary of Contents for OCENCO M-20.2

  • Page 1 OCENCO M-20.2 Self-Contained Self-Rescuer Emergency Escape Breathing Device INSTRUCTION MANUAL Manual No: NH22050 Revision F, ECN 2760 Page 1 of 16...
  • Page 3: Warnings And Cautions

    2) INDIVIDUAL WARNINGS MUST BE STRICTLY ADHERED TO WHICH, IF NOT, IT COULD RESULT IN INJURY AND OR DEATH OF PERSONNEL. 3) THE M-20.2 EEBD MUST NOT BE USED FOR PURPOSES OTHER THAN THOSE OUTLINED IN THIS MANUAL. 4) THE M-20.2 EEBD IS NOT TO BE USED UNDERWATER.
  • Page 4 The M-20.2 EEBD meets or exceeds the EEBD requirement for confined spaces onboard ships in the United States Navy, the 10 minute self-contained closed circuit breathing apparatus requirement for escape from confined space, and the EEBD requirement for use in maritime shipboard confined spaces as required in the SOLAS Convention.
  • Page 5: Method Of Operation

    SECTION 2 METHOD OF OPERATION Oxygen automatically and continuously flows from the cylinder to the breathing bag when the unit is pulled from the base. During inhalation, and whenever the bag flattens, the oxygen regulator increases the oxygen flow into the breathing bag.
  • Page 6: Donning Procedure

    SECTION 3 DONNING PROCEDURE The following are the donning steps for the stored configuration of the M-20.2 EEBD. These six steps must be practiced numerous times until they become second nature. To fit the neck strap, simply place the neck strap over the head and pull upward on the o-ring to shorten the neck strap.
  • Page 7 13. Base: features integral belt loops. If belt worn, the base stays on the belt after the M-20.2 EEBD has been removed from the case. The base has an overcase that provides increased abrasion and impact resistance.
  • Page 8 9 & 16 Page 8 of 16...
  • Page 9: Specifications

    Container, (P/N648000), and then placed in a rigid bracket securely fastened to a wall or other substantial structure. (4) If belt worn, the M-20.2 EEBD must be worn on the person and initial date of use recorded on the Band Label.
  • Page 10 SECTION 8 HOW TO INSPECT THE M-20.2 EEBD The inspections for the M-20.2 EEBD are visual. DO NOT lift the yellow latch or open the clear case to inspect the M-20.2 EEBD. The inspections described below shall be performed on each M-20.2 EEBD upon deployment.
  • Page 11 6. Do not drag the M-20.2 EEBD on the ground. 7. Do not place the M-20.2 EEBD near heat greater than 149°F (65°C). Do not put tape or stickers on the M-20.2 EEBD that would impede its opening or the reading of the gauge.
  • Page 12 WHEN TO USE THE M-20.2 EEBD The M-20.2 EEBD should be used immediately at the first indication of a fire or explosion, even if smoke is not visible. Carbon monoxide is odorless and colorless. You could breathe a fatal amount of carbon monoxide before smoke is present.
  • Page 13 1. The M-20.2T Trainer is worn on the belt to demonstrate the proper orientation on the belt or is placed in the blue Secondary Container to simulate the stored position. 2. The Latch assembly is identical to the M-20.2 EEBD, so that the opening of the M-20.2T Trainer is practiced “hands on”.
  • Page 14 B. The following are steps to clean and re-pack the M-20.2T Trainer: 1. Remove the Mouthpiece from the Scrubber by pressing the release button with a standard pencil erasure or similar object and pulling upwards on the Mouthpiece removing it from the Scrubber. 2.
  • Page 15 OCENCO, INCORPORATED PLEASANT PRAIRIE, WI USA (262) 947-9000 MODEL M-20.2 CLOSED-CIRCUIT COMPRESSED OXYGEN ESCAPE SELF-CONTAINED BREATHING APPARATUS THIS RESPIRATOR IS APPROVED ONLY IN THE FOLLOWING CONFIGURATIONS: Optional Optional Optional Optional Alternate Alternate Cautions TC # Protection overcase overcase Face extended...
  • Page 16 LakeView Corporate Park 10225 82nd Avenue Pleasant Prairie, Wisconsin 53158-5801 United States of America Telephone: (262) 947-9000 Telefacsimilie: (262) 947-9020 www.ocenco.com Page 16 of 16...

Table of Contents