Table of Contents
Advertisement
SC-3 Controller
FUNCTION
OUTDOOR
BOILER SUPPLY
BOILER TARGET
BOILER 1 HOUR
BOILER 2 HOURS
BOILER 3 HOURS
Follow the above procedure for all remaining boiler stages
VIEW THE PERFORMANCE
DESCRIPTION
Current outdoor air temperature
as measured by the outdoor
sensor.
Current boiler supply water
temperature as measured by the
boiler supply sensor.
Boiler target temperature is the
temperature the control is trying
to maintain at the boiler supply
sensor.
The total running time of
module 1 since this item was
last cleared.
The total running time of
module 2 since this item was
last cleared.
The total running time of
module 3 since this item was
last cleared.
Press the Menu button until VIEW is visible on the top line of the display.
Press the Item button until OUT appears. Read the numeric display.
Press the Menu button until VIEW is visible on the top line of the display.
Press the Item button until BOIL SUP appears. Read the numeric display.
Move the Adv/ Installer DIP switch to the Adv position temporarily.
Press the Menu button until VIEW is visible on the top line of the display.
Press the Item button until BOIL TARG appears. Read the numeric display.
Move the Adv/ Installer DIP switch back to the Installer position.
Move the Adv/Installer DIP switch to the Adv position temporarily.
Press the Menu button until VIEW is visible. Press the Item button until
BOIL appears on the second line of the display, and 1 in the lower right
section. Read the numeric display in hours. To clear this item back to 0,
press the Up and Down buttons simultaneously while viewing this item.
Move the Adv/Installer DIP switch back to the Installer position.
Move the Adv/Installer DIP switch to the Adv position temporarily.
Press the Menu button until VIEW is visible. Press the Item button until
BOIL appears on the second line of the display, and 2 in the lower right
section. Read the numeric display in hours. To clear this item back to 0,
press the Up and Down buttons simultaneously while viewing this item.
Move the Adv/Installer DIP switch back to the Installer position.
Move the Adv/Installer DIP switch to the Adv position temporarily.
Press the Menu button until VIEW is visible. Press the Item button until
BOIL appears on the second line of the display, and 3 in the lower right
section. Read the numeric display in hours. To clear this item back to 0,
press the Up and Down buttons simultaneously while viewing this item.
Move the Adv/Installer DIP switch back to the Installer position.
STEPS
22
Advertisement
Table of Contents
