Behringer VIRTUALIZER PRO DSP2024P User Manual page 8

1
Both the LED CHAINS display the intensity of the input signal in dB in relation to the nominal level,
which is selected on the rear panel with the OPERATING LEVEL switch.
2
After you switch on the VIRTUALIZER PRO, you can read the name of the last used effect on the LED
DISPLAY. When editing, the LED DISPLAY shows the parameter's name along with a 4-digit
alpha-numeric display that shows the absolute parameter's value.
3
To the right of the LED DISPLAY are four STATUS LEDs which indicate the type of value you are
working with. You may do any of the following:
set the absolute value of an effect parameter ("%"),
increase or decrease the amplitude or determine the threshold point of the compressor ("dB"),
modify a frequency ("Hz") or
modify a time parameter ("sec").
4
The ALGORITHM GROUPS LED CHAIN indicates which category the selected effect belongs to.
Altogether the DSP2024P offers eight different algorithm groups.
5
Every preset in the DSP2024P allows you to edit at least four effect parameters. The EDIT-LED-CHAIN
indicates which parameters are adjusted by the four EDIT CONTROLs. If the top LED lights up,
controls the parameter EDIT A,
with you change the setting of parameter EDIT D. If the middle LED of the EDIT-LED-CHAIN lights
up, the four EDIT CONTROLs modify the parameters that are arranged to its left and right. The lower
LED functions correspondingly.
For the exact meaning of the individual effect parameters, see chapter 7.1.
8
VIRTUALIZER PRO DSP2024P
Fig. 1.2: Display section of the VIRTUALIZER PRO
Fig. 1.3: Function keys, controls and jog wheel
controls EDIT B,
1. INTRODUCTION
helps in changes of parameter EDIT C and