Related Manuals for Omnex R1300
Summary of Contents for Omnex R1300
- Page 1 MODEL R1300 RADIO CONTROL SYSTEM ALTEC AD108 TRAILER REEL #74 - 1833 COAST MERIDIAN ROAD PORT COQUITLAM, B.C. V3C 6G5 PHONE (604)944-9247 FAX (604)944-9267...
-
Page 2: Table Of Contents
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including that which may cause undesired operation. Changes or modifications not expressly approved by OMNEX Control Systems Inc. can void the users authority to operate this equipment! -
Page 3: Installation
Select a suitable location on the machine that will protect the receiver box from impact damage. A location that protects the receiver from direct exposure to the weather is desirable. If the box must be located outside, mount it with the power and antenna cables facing down to allow water to drain away. ! IMPORTANT: The receiver box is supplied with rubber shock mounts to prevent damage from shock or vibration. -
Page 4: Operation
The receiver box is supplied with a 3 ft. "pigtail" cable that must be connected to the machine remote control interface. The wires in the pigtail cable are individually labeled as to function. The following chart relates the receiver connector wiring to the machine functions: FUNCTION CONNNECTOR PIN # Ground... -
Page 5: Receiver
To switch on the transmitter first release the red STOP button by turning clockwise, then momentarily press the ON button. (The transmitter will not switch on if the STOP button is depressed). The ON light will glow red indicating the transmitter is on and ready to use. The receiver will now respond to the function switches. - Page 6 POWER: Indicates that 12 volt DC power is applied to the receiver. Indicates that information from the transmitter is being successfully received. If the light flickers occasionally this indicates that interference is present on some frequencies. This is not a problem since this is a spread spectrum system and changes frequency many times each second.
-
Page 7: Basic Troubleshooting
this application, only the Start PWM and Max PWM will be of concern. These set the endpoints (min and max) of the speed potentiometer. To change a parameter, press the buttons under the "Param" lights until the desired parameter is lit up. In this application select only Start PWM or Max PWM. - Page 8 HI/LO ON WARRANTY OMNEX CONTROL SYSTEMS INC. Warrants to the original purchaser that the OMNEX radio remote control system is free from defects in materials and workmanship under normal use and service for a period of ONE YEAR parts (EXCLUDING: SWITCHES, CRYSTALS, OR...
- Page 9 PARTS SUBJECTED TO UNAUTHORIZED REPAIR OR MODIFICATION) and labor from the date of delivery as evidenced by a copy of the receipt. OMNEX's entire liability and your exclusive remedy shall be, at OMNEX's option, either the (a) repair or (b) replacement of the OMNEX radio control system, which is returned to OMNEX freight prepaid with a copy of the receipt.
Need help?
Do you have a question about the R1300 and is the answer not in the manual?
Questions and answers