Advertisement
Quick Links
OKIN Refined Electric Technology Co., Ltd
Operating Manual of Remote Control system
1、
Interface of the remote control
2、Button description
A.
HEAD UP button：Press and hold the button, the Head actuatorwill go up. Stop
when released.
B.
HEAD DN button： Press and hold the button, the Head actuator will go down. Stop
when released.
C.
FOOT UP button：Press and hold the button, the Foot actuator will go up. Stop
JLDK.42.18.14 UserManual
Page 1 of
5
Advertisement
Summary of Contents for OKIN JLDK.42.18.14
- Page 1 OKIN Refined Electric Technology Co., Ltd JLDK.42.18.14 UserManual Operating Manual of Remote Control system 1、 Interface of the remote control 2、Button description HEAD UP button：Press and hold the button, the Head actuatorwill go up. Stop when released. HEAD DN button： Press and hold the button, the Head actuator will go down. Stop when released.
- Page 2 OKIN Refined Electric Technology Co.,Ltd when released. FOOT DN button：Press and hold the button, the Foot actuator will go down. Stop when released. LIFT UP button：Press and hold the button, the Lift actuator will simultaneously go up. Stop when released.
- Page 3 OKIN Refined Electric Technology Co.,Ltd The procedure to set these special positions is below: Step 1: Adjust the Head and Foot position or Lift position to a desired position by pressing the button HEAD_ UP or HEAD_DOWN or FOOT_UP or FOOT_DOWNor LIFT_UP or LIFT_DOWN;...
- Page 4 OKIN Refined Electric Technology Co.,Ltd Step2: Power on the control box. Step3:Press and hold the pairing Tact Switch on the control box with the pairing LED turning on until the pairing LED on the control box turns off;then release the Tact Switch and the pairing Led beginsflashing that indicates the control box is pending to pair.
- Page 5 OKIN Refined Electric Technology Co.,Ltd FCC ID: PCU-JLDP03045 IC: 21319-JLDP03045 The control box is designed for using the SMPS of 29VDC/ around 2A as the power. It is necessary to use the SMPS provided by us when normal operation. In the case of the AC power utility failure, the batteries for backup of 18VDC can be used as the power.
- Page 6 FCC Statement Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired ISED RSS Warning:...