Magnetic Stripe Card Reader & Smart Card Introduction ...7 Handset and the Base Connection ..........8 Rechargeable Battery Cover Installation ........9 Rechargeable Battery Installation..........11 SAM Card Installation...............12 1.10 Paper Roll Installation...............13 1.11 Power ..................15 2. Program Manager ..................16 Castles Technology Co., Ltd. All rights reserved. 3/20...
Mode Under The Program Manager Screen. Press Cancel Key Will Go Back To The Program Manger Screen. F2 Key : Set default application F3 Key:Delete application from Program Manager. F4 Key : Programmable by application Castles Technology Co., Ltd. All rights reserved. 4/20...
1.5 Magnetic Stripe Card Reader & Smart Card Introduction Magnetic Stripe Card Should Be Placed On Card Reading Slot With Magnetic Stripe Facing Left, Swipe The Card From Top To The Bottom. Insert User IC Card With Chip Facing Up. Castles Technology Co., Ltd. All rights reserved. 7/20...
VEGA5000 User's Manual V0.4 1.7 Rechargeable Battery Cover Installation Step1: Align the battery cover to the middle location of machine then cover down. Step2: Push the battery cover to the end Castles Technology Co., Ltd. All rights reserved. 9/20...
Page 10
VEGA5000 User's Manual V0.4 Step3: Switch the latch to the left. Castles Technology Co., Ltd. All rights reserved. 10/20...
VEGA5000 User's Manual V0.4 1.8 Rechargeable Battery Installation VEGA5000 use rechargeable Li Polymer battery, 7.4V, 1050mAh. 1. Please use attached rechargeable lithium battery pack. And make sure to fully charge the battery up to at least 2 hours. 2. Please turn on both the power of the handset and the base to charge the battery automatically.
VEGA5000 User's Manual V0.4 1.9 SAM Card Installation 1. Open The Battery Cover To Find 4 SAM Card Slots SAM3 SAM1 SAM4 SAM2 Castles Technology Co., Ltd. All rights reserved. 12/20...
2. Insert The SAM Card To The SAM Slot As The Below Picture SAM3 SAM1 SAM4 SAM2 1.10 Paper Roll Installation Insert The Paper Roll To The Box And Pull The Paper Down As The Picture. Castles Technology Co., Ltd. All rights reserved. 13/20...
Page 14
VEGA5000 User's Manual V0.4 Close The Paper Roll Box To Start Paper Loading. The dimension of paper roll as below. Width : 57mm Outside diameter : 40mm Castles Technology Co., Ltd. All rights reserved. 14/20...
VEGA5000 User's Manual V0.4 2. Program Manager After power on the terminal, the terminal will enter the Program Manager. Press F1 button and enter the system menu. Castles Technology Co., Ltd. All rights reserved. 16/20...
Page 17
F2 button to set default AP in the Program Manager screen first. Dflt Name : If user set a default AP in Program Manager, the AP name will show here. Castles Technology Co., Ltd. All rights reserved. 17/20...
Page 18
Set USB Host : When it enables, the terminal can use USB as a host. 5. Test Utility The VEGA5000 provides a utility program for module testing, downloading… etc. This chapter describes the usage and testing functions of Test Utility The functions of Utility program include: ...
Page 19
VEGA5000 User's Manual V0.4 Input password 8418 and press OK to execute factory reset. After few seconds, it will show OK and go back to Program Manager. Castles Technology Co., Ltd. All rights reserved. 19/20...
Page 20
VEGA5000 User's Manual V0.4 7. Power Off Turn off the terminal. Castles Technology Co., Ltd. All rights reserved. 20/20...