ICON 51201 Installation Instructions

7929 Lincoln Ave. Riverside, CA 92504
Phone: 951.689.ICON Fax: 951.689.1016
COMPONENTS INCLUDED
(2) 158509 07+ TUNDRA RXT LEAF PACK
(2) 158509 3RD ADDITIONAL LEAF
HARDWARE INCLUDED
(4) SPRING CLIP

TOOLS REQUIRED

JACK
JACK STANDS
TORQUE WRENCH
9/16" SOCKET / WRENCH
TECH NOTES
THE ICON RXT LEAF SPRING IS MODULAR, MEANING THAT YOU CAN CONFIGURE THE SPRING PACK
TO YOUR DESIRED SETTING FROM THESE AVAILABLE OPTIONS:
OPTION #1 - THE SPRING IS SHIPPED AT THIS SETTING (LIGHTEST SPRING RATE).
OPTION #2 - REPLACE THE 3RD SPRING (COUNTING FROM THE TOP DOWN) WITH THE ADDITIONAL
LEAF.
OPTION #3 - PLACE THE ADDITIONAL LEAF BETWEEN THE 2ND AND 3RD SPRING (COUNTING FROM
THE TOP DOWN). DO NOT REMOVE LEAF FROM SPRING PACK.
ICON'S MEASURED SPECS FROM THE TEST TRUCK (2016 4WD CREW CAB TUNDRA):
OPTION #1 - LIFT HEIGHT OVER STOCK: + 1.75" (UNLOADED)
(RECOMMENDED FOR CONSTANT LOAD UP TO 250LBS)
OPTION #2 - LIFT HEIGHT OVER STOCK + 3.00" (UNLOADED)
(RECOMMENDED FOR CONSTANT LOAD UP TO 500LBS)
OPTION #3 - LIFT HEIGHT OVER STOCK: + 4.00" (UNLOADED)
(RECOMMENDED FOR CONSTANT LOAD UP TO 750LBS)
INSTALLATION
1
. Using a properly rated jack, raise the rear of the vehicle and support the frame rails with jack stands. Ensure the jack stands are
secure and set properly before lowering the jack. NEVER WORK UNDER AN UNSUPPORTED VEHICLE. Remove the rear wheels.
2
. Remove the lower shock bolt using (2) 19mm.
3
. Disconnect the parking brake bracket from the axle using a 12mm.
4
. Support the axle using the floor jack. Remove the U-bolts from one side of the truck using a 19mm.
5
. Slowly lower the axle being careful to not overextend brake lines or ABS wires.
6
. Remove the pivot bolt from the front frame mount using (2) 19mm. [FIGURE 1]
7
. Remove the upper and lower nut from the spring shackle using a 19mm.
(1) 158509H 07+ TUNDRA RXT HARDWARE KIT
(1) 52000 7.5" TOYOTA U-BOLT KIT
158509H HARDWARE KIT
(2) GALVANIZED LINER
7/8" SOCKET / WRENCH
12MM SOCKET / WRENCH
17MM SOCKET / WRENCH
19MM SOCKET / WRENCH
FIG.1

51201 INSTALLATION INSTRUCTIONS

PART #
07-UP TUNDRA MULTI-RATE RXT
51201
** READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH
BEFORE BEGINNING INSTALLATION! IF THESE INSTRUCTIONS ARE
NOT PROPERLY FOLLOWED SEVERE FRAME, SUSPENSION AND TIRE
DAMAGE MAY RESULT TO THE VEHICLE!
** ICON VEHICLE DYNAMICS RECOMMENDS THAT YOU EXERCISE
EXTREME CAUTION WHEN WORKING UNDER A VEHICLE THAT IS
SUPPORTED WITH JACK STANDS.
** ICON VEHICLE DYNAMICS RECOMMENDS ALL INSTALLATION TO
BE PERFORMED BY A PROFESSIONAL SHOP/SERVICE TECHNICIAN.
PRODUCT FAILURE CAUSED BY IMPROPER INSTALLATION WILL NOT BE
COVERED UNDER ICON'S WARRANTY POLICY.
DESCRIPTION
LEAF SPRING KIT
WARNING!
11-27-2017 REV.A
1