Connecting The Ipod - Scion PT546-00081 Owner's Manual

About iPod software version
The iPod software versions that can
be used with this unit are as follows
(operations verified as of November
2006):
iPod (3rd generation)
iPod (4th generation)
iPod (5th generation)
iPod mini
iPod photo
iPod nano
iPod nano (2nd generation)
iPod shuffle is not supported.
Please note that no guarantee applies to
*
iPod operations and future updated versions
of iPod software.

Connecting the iPod

Connect the iPod connector.
Connect the iPod as indicated in the
figure below using the supplied
cable.
ver: 2.3.0
ver: 3.1.1
ver: 1.2.0
iPod with Dock connector port
ver: 1.4.1
ver: 1.2.1
ver: 1.2.0
ver: 1.0.1
Dock connector
When connecting the iPod, remove
a headphone cable from the iPod.
Connection location differs depending on
*
the vehicle.
Vehicle type Connection location
tC Connect to the iPod connector
in the center console box.
xB Connect to the iPod connector
near the parking brake.
xD Connect to the iPod connector
near the cup holder.
To the vehicle's
iPod connector *
1 ft. 6 in. ( 45 cm )
As soon as the iPod is connected,
its power is automatically turned
on.
While the iPod is connected to this
unit, SCION (or (check mark)) is
displayed on the iPod.
• When the ignition switch is set to
ACC or ON, the iPod's battery is
charged while the iPod is con-
nected to this unit.
• While the iPod is connected to
this unit, the iPod itself cannot be
turned on or off.
• The iPod connected to this unit is
turned off about two minutes
after the ignition switch is set to
OFF.
NOTICE
To resolve most problems
when using your iPod with
the Scion Audio system, dis-
connect your iPod from the
vehicle iPod connection and
reset it.
For instructions on how to
reset your iPod, refer to your
iPod Owner's Manual.
17