Subscribe to Our Youtube Channel
Related Manuals for HomComfort HCFTALOAK
Summary of Contents for HomComfort HCFTALOAK
- Page 1 Model: HCFTALOAK United States Stove Company 227 Industrial Park Road South Pittsburg, TN 37380 www.usstove.com FOR TECHNICAL ASSISTANCE: PHONE: (800) 750-2723 853159---0802H...
-
Page 2: Safety Information
Safety Information Please read and understand this entire manual before attempting to assemble, operate or install this appliance. This appliance has been tested to and complies with ANS Z21.97 • CSA 2.41-(2014), Outdoor Decorative Gas Appliances. The installation must conform to local codes or in the absence of local codes, to the National Fuel Gas Code, ANSIZ223.1. - Page 3 DANGER: WARNING: CARBON MONOXIDE HAZARD Do not store or use gasoline or other flammable • This fire pit is a combustion appliance. All vapors and liquids in the vicinity of this or any other combustion appliances produce carbon appliance. An LP-cylinder not connected for use monoxide (CO) during the combustion process.
-
Page 4: Before Operating
WARNING: WARNING: • Alert children and adults to the hazards of high • Non-rechargeable batteries are not to be surface temperatures. Stay away from these recharged. Do not mix different types of batteries surfaces to avoid burning skin or igniting clothing. such as alkaline, carbon-zinc, or rechargeable •... - Page 5 Assembly Before beginning assembly of product, make sure all parts are present. If any part is missing or damaged, do not attempt to assemble the product. Contact customer service for replacement parts. 1. Locate 3 panels (C/E/F) and the door panel with door (H). Align holes in all panels and insert M6 X 20 bolts through M6 washer, then insert bolt/washer through holes.
- Page 6 4. Disassemble the washers and screws located in the four corners of the burner assembly (B), lower the burner assembly (B) down into the table top (D). Align the holes in the four corners of the burner assembly (B) with the holes in the table top (D) and assemble the burner assembly (B) to the table top (D) using the four screws and washers.
- Page 7 8. Remove the rubber cap on the electronic igniter (L) by unscrewing and slide battery into the battery slot. Make sure the positive side of the battery faces outwards. Screw the electronic igniter cap (L) over the battery tightly. 9. Close the door and turn the door knob to hold the door shut. Fire pit assembly is now complete! 10.
- Page 8 12. Use this fire pit only with a vapor withdrawal supply system. See Chapter 5 of the standard for storage and handling of liquefied petroleum gas, ANSI/NFPA 58. Your local library or fire department should have this book. Storage of an appliance indoors is permissible only if the cylinder is disconnected and removed from the appliance.
- Page 9 Operation Instructions LEAK TEST WARNING: • Perform all tests outdoors. • Extinguish all open flames. • NEVER leak test when smoking. • Do not use the fire pit until all connections have been leak tested and do not leak. Hose / Regulator Connection Regulator / Cylinder Connection 1.
-
Page 10: Before Lighting
WARNING: DANGER: VERY HOT WHILE IN OPERATION CARBON MONOXIDE HAZARD Never lean over the fire pit while in use. Do not touch For outdoor use only. Never use inside a house, or surfaces while the fire pit is in operation. Wait until the other unventilated or enclosed area. -
Page 11: Care And Maintenance
WARNING: FOR YOUR SAFETY Be careful when attempting to manually ignite this fire pit. Holding in the control knob for more than 10 seconds before igniting the gas will cause a ball of flame upon ignition. WHEN FIRE PIT IS ON Burner will display tongues of blue and yellow flame. -
Page 12: Troubleshooting
STORAGE BETWEEN USES • Turn the control knob off. • Disconnect the LP source. • Store the fire pit in an area sheltered from direct contact with inclement weather (such as rain, sleet, hail, snow, dust and debris). • If desired, cover the fire pit to protect exterior surfaces and to help prevent build-up in air passages. Note: Wait until the fire pit is cool before covering. -
Page 13: Parts List
Parts List Key Part No Description Qty. 892957 Table Top Insert 81297 Burner Assembly ATTENTION: In order to maintain warranty, components must be replaced using original manufacturers parts purchased through your dealer or directly from the appliance manufacturer. Use of third party components will void the warranty. - Page 14 Notes -14-...
-
Page 15: Service Record
Service Record It is recommended that this unit is serviced regularly and that the appropriate Service Interval Record is completed. Service Provider: Before completing the appropriate Service Record below, please ensure you have carried out the service as described in the manufacturer’s instructions. - Page 16 Distributed By: United States Stove Company www.usstove.com 227 Industrial Park Rd (800) 750-2723 South Pittsburg, TN 37380 1 year limited warranty - Customers in the Continental US All components are warranted for a period of 1 year after date of purchase by the original owner against defects in materials and workmanship under normal use.
Need help?
Do you have a question about the HCFTALOAK and is the answer not in the manual?
Questions and answers