Mount The Oit To The Panel - Maple Systems HMI5056T Installation Manual

10

Mount the OIT to the Panel

Ends of screws must not
protrude from the clamp
Screw clamp locking
tabs go through the
slots
Screw Clamp Placement
Model
HMI5056T
HMI5080T
HMI5104T/X
HMI5121T/X
HMI5150X
STEPS:
1. Set the OIT in the panel cutout and hold it in place until all clamps are in position.
2. Tighten the screw clamps until all are uniformly snug.
Caution:
housing.
REINSTALLATION: Because the gasket will take a "set" to the panel, be sure to reinstall
the OIT to the same panel cutout when a NEMA 4 seal is required. For best results, also
replace the gasket itself.
In stall ing Screws to the OIT
Panel
Hold the OIT against
the panel until all screw
clamps are in position
Mount ing Clip Bracket Place ment
Left Side Right Side
0
0
0
2
2
Do not over-tighten the screws beyond snugness, or you may damage the
Tighten all screw clamps until
they are uniformly snug
Clamps Tightened
Top
0 2
0 2
0 3
2 2
2 2
Sil ver Plus Se ries
Panel
Bottom
2
2
2
2
2
1010-1006, Rev 01