Related Manuals for CM FG10
Summary of Contents for CM FG10
- Page 1 Floor Grinder Operating Manual Model # DFG-250E Model: FG10 Item # 1211250E Please read these instructions carefully before using.
-
Page 2: Table Of Contents
Page Number Contents Introduction and Description Technical Data Operation Safety Precautions Troubleshooting Maintenance Parts Diagram Parts List... -
Page 3: Introduction And Description
Introduction and Description This manual is intended to provide operation and service information necessary for the safe and efficient use of the Virginia Abrasives Floor Grinder.Operating or servicing the unit other than in accordance with the instructions given may subject the machine to conditions beyond its capability. This may result in the machine failure or personal injury. - Page 4 1730...
- Page 5 surface (use the bubble-level on the machine as a reference). Check that all nuts and bolts on the folding handle latch are tight and secure. 6.Raise the grinding plates from the floor. 7.Start the motor by pressing the black switch on the starter box. 8.Lower the grinding plate and begin grinding.
-
Page 6: Safety Precautions
Safety Precautions The Bycon Floor Grinder has been designed to minimize noise, vibration levels and to provide maximum operator safety. However, incorrect use of the grinder may cause serious injury and therefore the following precautions must be taken: 1.Do not use the grinder for longer than prescribed in your local environmental working regulations, as the noise load from extensive daily use may result in hearing damage. -
Page 7: Troubleshooting
Use engineering controls to control dust, mist and fumes at the source wherever possible.Use good work practices and follow the recommendations of the manufacturers/suppliers, OSHA/NIOSH, and occupational and trade associations.Water should be used for dust suppression when wet grinding/cutting/drilling is feasible.When the hazards from inhalation of dust, mists and fumes cannot be eliminated,the operator and any bystanders should always wear a respirator approved by NIOSH/MSHA for the material being used. -
Page 8: Parts Diagram
Check the security of the adjustable folding handle latch periodically. The wheel bearings use sealed bearings and require no regular greasing. Parts Diagram Code Description Drawing No. .FG10-001 Handle .FG10-002 Upper arm SHMDJ71501 .FG10-003 Switch assembly .FG10-004... - Page 9 .FG10-011 Ф10 Flat washers .FG10-012 M8X25 hex screw .FG10-013 Dust shroud SHMDJ71504 .FG10-014 M12X25 socket hexagon screw .FG10-015 Detachable shroud SHMDJ71505 .FG10-016 Shroud plastic wear strip set（long） .FG10-017 Shroud plastic wear strip set（short） .FG10-018 motor driving sleeve SHMDJ71503 .FG10-019 M10X30 hex screw .FG10-020...
Need help?
Do you have a question about the FG10 and is the answer not in the manual?
Questions and answers