Set The Plastic Stop Guide - Scott 1800 Instruction Manual

2 Installation
Fig. 2-10. Manually Feed and Cut Plastic
Fig. 2-11. Feed Piece of Plastic
Fig. 2-12. Bring Stop Guide to End of Plastic
and Add 1/16", Tighten Guide
2- -8
A
2.1.6

Set the Plastic Stop Guide

To set the Plastic Stop Guide, do the following:
Step: 1. Run tape through the machine past the
punch and die set then, cut off the plastic
with the manual switch.
Step: 2. Feed out a piece of plastic with the
manual feed switch but DO NOT CUT the
plastic.
Step: 3. Bring the stop guide (A) up to the end of
the plastic and then back it away about
1/32 to 1/16th of an inch. The purpose of
the plastic stop is to help keep the plastic
registered to the same spot on the paper.
Step: 4. Tighten the guide in place.
Scott 1800 Issue 1