Vcr And Cable Box Connection; Amplifier Connection (To Audio Amp) - Panasonic CT-20SX10 Operating Instructions Manual

0363 E Prod .fm Page 7 Wednesday, February 7, 2001 10:17 AM

VCR and Cable Box Connection

CABLE BOX
ANT IN ANT OUT
Incoming Cable

Amplifier Connection (To Audio Amp)

Follow this diagram when connecting your television to both a VCR and a cable box.
VCR
VIDEO OUT
S-VIDEO
VIDEO
L
AUDIO OUT
R
ANT IN ANT OUT
Note: The remote control must be programmed with supplied codes to operate the VCR and cable box.
See Programming the Remote Control in the Remote Control Quick Reference Guide.
Viewing a premium (scrambled) cable channel
Procedure
1. Tune the television to CH 3 or 4 depending on the Cable box RF out.
2. Using the cable box, tune to the premium cable channel you want to view.
Viewing a premium (scrambled) cable channel using the A/V input jacks
1. Press the TV/VIDEO button on the remote control to select the video input (VIDEO 1,
VIDEO 2, etc.) connected to your VCR.
2. Turn the VCR ON.
3. Tune the VCR to Channel 3 or 4, depending on the switch setting on the back of VCR.
4. Using your cable box, tune to the premium cable channel you want to view.
Connect to an external audio amplifier input for listening through a stereo system.
Note: TO AUDIO AMP terminals cannot be connected directly to external speakers.
Audio Adjustments
1. Select TV SPEAKERS ON from AUDIO menu.
2. Set amplifier volume to minimum.
3. Adjust TV volume to desired level.
4. Adjust amplifier volume to match the TV.
5. Select TV SPEAKERS OFF&VAO from AUDIO menu.
6. Volume, mute, bass, treble and balance are now controlled from the TV.
Note: In OFF&FAO the volume is controlled by the external amplifier.
O
PTIONAL
TERMINALS ON BACK OF TV
S-VIDEO
Y
P L
B
P
R
R
ANT
VIDEO AUDIO
COMPONENT INPUT INPUT
VIDEO INPUT 1
CABLES NOT INCLUDED
E C
QUIPMENT ONNECTIONS
Use either the
S- Video or Video
connection.
VIDEO
L
L
TO AUDIO
AMP
R
R
AUDIO
2
7