Platen Removal 4375 - SafetySpeed 3760 Owner's Manual

Sanding Operations
4375 Platen Removal
To remove the platen, complete the following
steps:
1. Lower the platen by turning the platen
adjustment knob to the 6:00 position (43"x
75" only.)
2. Release sanding head hold down lever.
3. Remove the sanding spacer block. See Fig. 52.
4. Pull the platen out from the belt loading door.
See Fig. 53.
The platen should be inspected periodically for
wear. Refer to the platen maintenance instructions
in the Maintenance Section.
28
Loading
Door
Sanding
Head
Hold
Down
Lever
Figure 52: Platen
Platen
Figure 53: Remove Platen As Shown
Belt
Spacer
Block