Advertisement
MOU TI G I STRUCTIO S
⚠
arninge!
We strongly recommend to let an Öhlins dealer
install this product.
⚠
arninge!
If you work with a lifted vehicle, make sure that it
is safely supported to prevent it from tipping over.
otee!
1
When you work with this product, see the
vehicle service manual for vehicle specific
procedures and important data.
otee!
1
Before you install this product clean the vehicle.
1
Put the motorcycle on a work stand so that the
rear wheel barely touches the ground.
2
Remove the seat and the tank side panel.
3
Remove the screws on the tank, one in the
front and one on each side.
4
Pivot the tank and loosen the upper attachment
nut of the original shock absorber.
5
Remove the screw that attaches the pull rods
to the swing arm. Remove the lower shock
absorber attachment.
6
Remove the upper attachment of the original
shock absorber. Remove the original shock
absorber.
7
Remove the original spacer between the upper
shock attachment and the frame.
8
Use the original screws and install the Öhlins
shock absorber in the same position as the
original shock absorber.
9
Install the tank, side cover and the seat. Install
all removed parts in the same positions as they
were before removal.
otee!
1
Lower the vehicle so that the suspension
is slightly compressed before you tighten
the screws.
✋
Cautione!
Make sure that you tighten all screws to the
correct torque and that nothing fouls or restricts
movement of the shock absorber/front fork/
steering damper when the suspension is fully
compressed or extended.
2
Advertisement
