Download Print this page

Dakota Digital VFD3-55J-CJ Mounting Instructions page 2

55-86 jeep cj installation guide

Advertisement

Remove the cardboard and/or plastic light tubes. Remove the rivets holding in the blue light
covers. Cut a slot in the rear of the can for the ribbon cable to pass through.
Pass the ribbon cable through the slot and attach the system
to the can using the supplied hardware. Start all of the
supplied screws in available holes. Use the holes on the
mounting ears to align the system. When straight, tighten
the screws, being careful not to over tighten.
DAKOTA DIGITAL offers complete service and repair of its product lines. In addition, technical consultation is available to help you work through any
questions or problems you may be having installing one of our units.
Should you ever need to send the unit back for repairs, please package the product in a good quality box along with plenty of packing material. Ship
the product by UPS or insured Parcel Post. Be sure to include a complete description of the problem, your full name and address (street address
preferred), and a telephone number where you can be reached during the day. An authorization number for products being returned for repair is
needed. We will contact you if any repair charges exist. Any returns for warranty work must include a copy of the dated invoice or bill of sale.
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to
cause cancer and birth defects or other reproductive harm. For more information go to
Flatten the tabs that hold the light tubes, bending them
into the light holes. There are four dimples on the bottom
near the Temp and Fuel gauge mounting holes that need
to be flattened also.
Reattach the bezel
and lens assembly
by recrimping the bezel to the can. You can slightly
rotate the bezel to insure proper alignment. To protect
the ribbon cable from abrasion, you can use the
supplied grommet edging material or apply silicone
around the slot that was cut.
Depending on the year of the vehicle, you may be able
to install the pulse generator to the speedometer end of
the original cable.
SERVICE AND REPAIR
www.P65Warnings.ca.gov

Advertisement

loading