Ford RANGER 2019 Quick Reference Manual page 8

CONVENIENCE
REMOTE CONTROL ICONS*
Press once to lock all doors.
Press once to unlock the driver door.
Press to start the panic alarm. Press again or switch on the
ignition to stop the alarm.
Car finder: Press twice within three seconds to locate your
vehicle. The horn sounds and the direction indicators flash.
UNIVERSAL GARAGE DOOR OPENER*
The universal garage door opener replaces the common hand-held
garage door opener with a three-button transmitter located on the
driver sun visor. The system includes two primary features, a garage
door opener and a platform for remote activation of devices within
the home. This functionality allows you to program garage doors, as
well as entry gates, security systems, entry door locks and home or
office lighting.
MYKEY®
MyKey allows you to program certain driving restrictions in order to
promote good driving habits. For complete information, refer to the
MyKey chapter in your Owner's Manual.
REMOTE START*
Remote start allows you to start the engine from outside your vehicle
using your key.
14
To start, press and then press twice within three seconds.
Before driving your vehicle, you must press the push button ignition
switch on the instrument panel while applying the brake pedal. You
can also turn your vehicle off from outside after a remote start by
pressing once. If your vehicle is equipped with remote feedback,
an LED on the key provides status feedback of remote start or stop
commands. A solid green light means the remote start or extension
was successful while a blinking red light means the remote start or
stop has failed. A solid red light means that the remote stop was
successful and the engine is off. When the system is waiting for a
status update from the vehicle, you will see a blinking green light.
AUTOMATIC HIGH BEAM CONTROL*
Automatic high beam control can sense when to turn your high beams
on and off. A camera mounted behind the rear view mirror detects
approaching lights. The automatic high beam control decides when to
turn your high beams on or off to give you the best visibility on a dark
road and to avoid glaring your high beams at approaching vehicles.
When it detects the headlights of an approaching vehicle, the tail
lamps of the preceding vehicle, or street lighting, the system turns the
high beams off before they distract other drivers.
To activate the system, switch on automatic high beam control using
the information display and autolamps.
Switch the lighting control to the autolamps position.
*If equipped
CARGO AND TRAILER HOOKUP LAMPS*
Press the button on the lighting control to switch on the lamps.
NOTE: The lamps turn off when you reach 3 mph (5 km/h).
NOTE: The cargo lamps gradually turn off after a period of time.
INTELLIGENT ACCESS*
You can unlock and lock the vehicle without taking the key out of your
pocket or purse when your intelligent access key is within 3 feet (1
meter) of your vehicle.
To unlock, touch the unlock
sensor on the back of the
door handle for a brief period
and then pull on the door
handle, being careful to not
touch the lock sensor at the
same time or pull the door
handle too quickly.
To lock, touch the door handle lock sensor on the door for
approximately one second, being careful to not touch the unlock
sensor on the back of the door handle at the same time.
WINDSHIELD WIPER DE-ICER*
When you switch the heated rear window on, the windshield wiper
de-icer turns on.
AUTOWIPERS*
The wipers operate when the system detects moisture on the
windshield and adjusts the wiper speed automatically. Use the rotary
control to adjust the sensitivity of the rain sensor.
Low sensitivity: The wipers automatically operate when the sensor
detects a large amount of moisture on the windshield.
High sensitivity: The wipers automatically operate when the sensor
detects a small amount of moisture on the windshield.
NOTE: Keep the outside of the windshield clean. Dirt, bugs and
excessive road debris can prevent it from detecting rain.
To reduce smearing, we recommend the following:
Lower the sensitivity of the autowipers.
Switch to normal or high-speed wipe.
Switch the autowipers off.
NOTE: Make sure you switch off the windshield wipers before
entering a car wash.
WINDSHIELD WIPERS AND WASHERS
Use the rotary control on the stalk to adjust wipe interval.
Your vehicle may have speed-dependent wipers. When your vehicle
speed increases, the interval between wipes decreases.
*If equipped 15