Related Manuals for CENTURION SYSTEMS D5-EVO
Summary of Contents for CENTURION SYSTEMS D5-EVO
- Page 1 THEFT-RESISTANT CAGE D5-EVO THEFT-RESISTANT CAGE KIT INSTALLATION MANUAL Centurion Systems (Pty) Ltd www.centsys.com...
- Page 2 Americas, Australia and the Pacific Centurion Systems (Pty) Ltd reserves the right to make changes to the products described in this manual without notice and without obligation to notify any persons of any such revisions or changes. Additionally, Centurion Systems (Pty) Ltd makes no representations or warranties with respect to this manual.
- Page 3 Do not leave packing materials (plastic, polystyrene, etc.) within reach of children as such materials are potential sources of danger • Neither Centurion Systems (Pty) Ltd, nor its subsidiaries, accepts any liability caused by improper use of the product, or for use other than that for which the automated system was intended •...
-
Page 4: General Description
Centurion Systems (Pty) Ltd cannot be held liable under any circumstance for any damage, loss or action that results from your gate operator being tampered with. -
Page 5: Product Identification
2. Product Identification FIGURE 2. PRODUCT IDENTIFICATION 1. Theft-resistant cage overstrap 2. Closed-up mounting bracket 3. Mounting bracket 4. Discus padlock 5. Front bar 6. Padlock enclosure 3. Required Tools 1. Spanner – 17mm www.centsys.com page 5... - Page 6 4. Fitting the padlock to the front bar The padlock is supplied already fitted to the front bar. In the event that it needs to be refitted, the following instructions detail the procedure for doing so. FIGURE 3 FIGURE 4 Unlock the discus padlock Locate the padlock enclosure on the front FIGURE 5...
- Page 7 5. Theft-resistant cage installation IMPORTANT! For magnetic origin operator models, relocate gate magnet as close as possible to operator cover and reset gate Limits. Please take note of the positioning of the mounting brackets. They should be placed as shown Figure 9. FIGURE 9 Remove the side covers to access the mounting bolts...
- Page 8 Lift the motor with the inserted brackets and place over the mounting bolts and fasten them using the provided M10 washer and M10 nut FIGURE 12 With the brackets mounted in position, insert and and align the bracket strap in position as shown in Figure 13.
- Page 9 A finished installation should look like Figure 15 FIGURE 15 www.centsys.com page 9...
-
Page 10: Installation Handover
8. Installation handover Once the Theft-resistant cage has been successfully installed and its operation tested, it is important for the operation and safety considerations to be explained to the end-user of the system. Notes page 10 www.centsys.com... - Page 11 Notes www.centsys.com page 11...
- Page 12 The CENTURION and CENTSYS logos, all product and brand names in this document that are accompanied by the TM symbol are trademarks of Centurion Systems (Pty) Ltd, in South Africa and other territories; all rights are reserved. We invite you to contact us for further details.