Kintech Engineering EOL Zenith Quick User Manual page 9

EOL ZENITH DATA LOGGER |
Display
The liquid crystal display is built into the logger to facilitate site visits and is activated by pressing any key on the log-
ger keypad. The user can view real-time wind conditions as well as data logger settings.
As a power saving function, the display will always shut off after two minutes without any key inputs. The logger
continues to collect data while the display is off.
Communication status
In the upper right corner of the data logger display, the GSM/GPRS coverage and current communication status is
shown.
STATUS
GSM connection
GPRS connection
Internet connection
Online mode
Satellite mode
Connection error
E-mail transmission
For additional information on communication, please navigate to "Modem" in the data logger menu using the naviga-
tion keys. Go to STATUS > MODEM.
support@kintech-engineering.com
QUICK USER GUIDE
Battery
Modem
Cov: 23 e 04 b20 t08
95.124.149.111:02020
movistar.es
16:39:27
Time
DESCRIPTION
The communication between the data logger and the internal modem has
been established and the SIM card is now registered on the GSM network.
The data logger has now received a correct IP address.
The data logger is now connected to the Internet.
The data logger is now ready for receiving and transmitting data over the
Internet using the EOL Manager® software.
The data logger has been configured for satellite communication.
There is a communication error. It might be an incorrect PIN code.
Icon shown during an e-mail transmission.
Configuration file nº.
SIT:000000
01/01/2010
Date
Communication Status
ONLINE
GPS
GPS Signal
www.kintech-engineering.com
DISPLAY