Amcrest AC-2 Quick Start Manual

Quick
Start Guide
Connection & Installation
This section provides information about
pairing the handset with the camera.
Powering on the Camera
❶
Connect the included power
adapter to a wall outlet.
❷
Connect the camera to the
power adapter.
❸
Slide the ON/OFF switch to
the ON position.
Powering on the Handset
❶
Connect the included
power adapter to a wall outlet.
❷
Connect the handset to
the power adapter.
❸
Press and hold the power
button until the handset
powers on.
Once powered on, a battery icon with a lightning bolt
will display on the upper right-hand of the screen. This
indicates the handset is charging. When the handset is
completely charged, the battery indicator shown on
the screen will be full and you may disconnect it from
the charging cable as desired.
Pairing your Handset & Camera
By default, the camera and the handset comes paired
and should be ready to use, However, If for any
reason pairing needs to be reestablished between the
handset and the camera, please Follow these
instructions:
❶
Within the handset menu please navigate to the
setting icon
❷
Next, navigate to "Add" and press the
located between the standby
on the handset face.
❸
Now, select a channel and press
pairing process.
❹
Located under the camera, press and hold the
button while the camera is powered on. If the pairing
process was completed within the allotted time, you
should see an image captured by the camera unit.
Please note that the handset will only pair
within 15 seconds. If the camera does not pair
!
within this time you will need to begin the
process again.
Handset Button Menu
Icon Description Options
Display
On/O
Push to Talk Press and Hold to Speak
Menu Configuration Settings
Tilt Up Tilt Camera Up
Tilt Down Tilt Camera Down
Pan Right Pan Camera Right
Pan Left Pan Camera Left
Indicates if the device is
Power
powered on or o .
Indicates the status of the
Link
connected cameras. When lit
indicates there is no link.
button
and buttons
to start the