Graco SNUGRIDE Owner's Manual page 13

Insert Metal Clip Into New Location
15
Push metal clip down through the pad
and shell. Make sure the buckle's red
button is facing out.
16
Pull Up On Buckle to Check it is
Secured
Make sure buckle's metal clip is
completely through the pad and shell.
17
Place Harness Straps Over Child's
Shoulders
18
Buckle Harness Straps
Fit the two buckle tongues together and
push them into the buckle. You will hear a
"click" when buckle tongues are securely
attached. Pull up on the buckle tongue to
make sure it is securely attached.
19
Pull All the Slack Out From around
the Waist
Pull up on the harness strap. Do this to
both sides.
20
Tighten the Harness by Pulling the
Harness Adjustment Strap
When you are not able to pinch any
of the harness webbing at your child's
shoulder, the harness is tight enough.
Unsafe Vehicle Seat Locations
Never install this car seat in any of the
following vehicle seating locations:
21
rear-facing or side-facing vehicle seats
22
rear-facing with an active front air bag
23
Identify Your Seat Belt Type
There is only one type of vehicle seat
belts that can be used with this car seat:-
Combined Lap & Shoulder Seat-belt
3 connections points.
24
Place Car Seat Rear-Facing in the
Vehicle
Place the car seat on the vehicle seat.
Push it back until the front of the car seat
touches the vehicle seat back.
25
Put lap section of belt over car seat and
under the two belt hooks marked with
blue labels. Buckle the vehicle belt.
26
Place shoulder belt around the back of
the car seat exactly as shown, making
sure to run it through the center guides
on the back of the seat and below the
notch opposite the shoulder belt origin.
The seat belt should lay as flat as
possible and not be twisted. Make sure
buckle and seat belt are in line with each
other. Contact Graco if in doubt about
this point.
27
Tighten Vehicle Seat Belt
Lay your forearm across the car seat at
the belt path and push down. Pull on
the shoulder belt to tighten while feeding
the slack back into the retractor.
ACCESSORIES
28
INFANT PILLOW
Use only with the lowest two sets of
harness slots. To remove, remove the
harness straps from the junction plate
and pull the harness straps out. Remove
pillow.
Insert harness straps into the new location.
Make sure harness straps are not twisted
EN
13