Table of Contents
Advertisement
Quick Links
INSTALLATION MANUAL
EN
EN
CHAPTER INDEX
3.5 Box specification
This document is property of SENECA srl. Duplication and reproduction of its are forbidden (though partial), if not authorized.
Contents of present documentation refers to products and technologies described in it. Though we strive for reach perfection
continually, all technical data contained in this document may be modified or added due to technical and commercial needs; it's
impossible eliminate mismatches and discordances completely. Contents of present documentation is anyhow subjected to
periodical revision. If you have any questions don't hesitate to contact our structure or to write us to e-mail addresses as above
mentioned.
Z-MODEM
SENECA s.r.l.
Via
Austria 26
,
Tel. +39.049.8705355 - 8705359 Fax. +39.049.8706287
www.senec
Site:
Commercial
reference:sales@seneca.it
MI00
3342
INDUSTRIAL MODEM
GSM/GPRS Quadband
- 35127 -
P
ADOVA - ITALY
Technical assistance:
-E
Serie Z PC
Serie Z PC
support@seneca.it
ENGLISH 1/8
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Seneca Serie Z PC
Summary of Contents for Seneca Serie Z PC
-
Page 1: Table Of Contents
Commercial reference:sales@seneca.it This document is property of SENECA srl. Duplication and reproduction of its are forbidden (though partial), if not authorized. Contents of present documentation refers to products and technologies described in it. Though we strive for reach perfection continually, all technical data contained in this document may be modified or added due to technical and commercial needs; it’s impossible eliminate mismatches and discordances completely. -
Page 2: Preliminary Warnings
Before carrying out any operation it’s mandatory to read all the content of this user manual. Only electrical-skilled technicians can use the module described in this user manual. Specific documentation is available on www.seneca.it Only the manufacturer is authorized to repair the module or to replace damaged components. -
Page 3: Power Supply
3.2 Power supply Voltage 11..40 Vdc; 19..28Vac Consumption 2 W (standby), 6,5 W (MAX) 3.3 Environmental conditions Operating temperature From -10 to +50 °C Humidity 30..90% to 40°C not condensing Storage Temperature From -20 to +85 °C Protection degree IP 20 3.4 Standards Electromagnetic emission, industrial environment. -
Page 4: Preliminary Instructions For Use
4.0 PRELIMINARY INSTRUCTIONS FOR USE The module is designed to be installed on DIN46277 rail in vertical position. It is forbidden to place anything that could obstruct the ventilation slits. It is forbidden to install the module near heat sources. «Severe operating conditions»... -
Page 5: Sim Card Inserting
4. 3 SIM card Inserting Note: The SIM card must be inserted with Z-MODEM turned off to be detected. SIM, from slide connector. Front panel proper standoff insertion = 4.5mm. A f t e r t h e S I M c a r d i n s e r t i o n connect your antenna to connector located in the middle of front panel... -
Page 6: Purchase Order Code
7.0 PURCHASE ORDER CODE GSM/GPRS Quadband Industrial MODEM Z-MODEM DIN rail support with screw terminal P=35 mm AL1-35 Z-PC-DIN 1-35 DIN 1 slot support for rear connector P=35 mm PM002490 RS232 programming cable (DB9F-DB9M) A-GSM External GSM antenna dual band swing, cable 3,2 m PM002390 RS232 link adapter (included) 8.0 MODULE LAYOUT... - Page 7 ENGLISH 7/8 MI00 3342...
- Page 8 ENGLISH 8/8 03342...
Need help?
Do you have a question about the Serie Z PC and is the answer not in the manual?
Questions and answers