Long Term Storage - BBT -PHD-71CC Owner's Manual

Long Term Storage

If your auger will not be used for more than one month,
prepare it for long term storage.
Steps for Long Term Storage
1. Add fuel stabiliser
instructions.
2. Run engine for 10-15 minutes to ensure that the stabiliser
reaches the carburettor.
3. Remove the remainder of the fuel from the fuel tank
into an approved fuel container.
4. Remove auger from powerhead and apply a thin layer
of grease to the output shaft.
5. Remove all debris from auger and powerhead (engine).
6. Store auger and powerhead (engine) in a vertical
position.
Avoid injury! To avoid injury or death, never siphon
fuel by mouth.
Avoid injury! Never store auger with fuel in the fuel
tank inside an enclosed area or building.
To prevent accidental starting:
Avoid injury! Engine must be turned off and cooled,
spark plug wire must be removed from spark plug
before checking and adjusting engine or before any
repair or maintenance can be done.
Avoid injury! An adult must always do maintenance
and repair on engine and auger.
BBT-PHD-71CC
MAINTENANCE
according to manufacturer's
CAUTION
WWW.BBTA.COM.AU 13