Sony WH-CH700N Help Manual page 27

Wireless noise canceling stereo headset

Hide thumbs Also See for WH-CH700N:

Table of Contents

Touch [WH-CH700N].

If passkey (*) input is required on the display of the smartphone, input "0000."

The headset and smartphone are paired with each other and connected. You will hear a voice guidance

"BLUETOOTH connected".

If they are not connected, see

If [WH-CH700N] does not appear on the display, try again from step 3.

A Passkey may be called "Passcode," "PIN code," or "Password."

Hint

The above procedure is an example. For details, refer to the operating instructions supplied with your Android smartphone.

To delete all pairing information, see

Note

If pairing is not established within about 5 minutes, pairing mode will be canceled, and the headset will turn off. In this case, start

over from step 1.

Once Bluetooth devices are paired, there is no need to pair them again, except in the following cases:

Pairing information has been deleted after repair, etc.

When a 9th device is paired.

The headset can be paired with up to 8 devices. If a new device is paired after 8 devices are already paired, the paired device

with the oldest connection time is replaced by the new one.

When the pairing information for the headset has been deleted from the Bluetooth device.

When the headset is initialized, all pairing information is deleted. In this case, delete the pairing information of the headset from

the Bluetooth device, and then pair them again.

The headset can be paired with multiple devices, but can only play music from one paired device at a time.

Table of Contents