Product Overview - D-Link mydlink DNR-312L Quick Install Manual

1
2
3
4
1 Power Button
2
Audio In Port
3 Ethernet Port
4
Power Port
5
USB Ports
6
Audio Out Port
7 HDMI Port
8
Reset Button
9 Power LED
10 HDD LED
11
Network LED

Product Overview

5
6
7
8
Press to turn the device on or press and hold for five seconds to turn off.
Connect a microphone to use 2-way communication with your camera(s). Note that
your camera(s) must support this feature.
Connect the device to your router or switch using an Ethernet cable.
Connect the supplied power adapter to this port.
Connect a USB thumb drive or external hard drive (with external power supply) for extra
storage. You can also connect a USB mouse to control the interface when connected to a
TV or monitor via HDMI.
Connect external speakers for audio.
Connect to your TV or monitor using an HDMI cable.
Press and hold for 10 seconds to reset the device back to the factory default settings.
A solid green light indicates the device is powered on. This light will blink during boot-
up. If the power LED is off, the device is not powered on.
A solid green light indicates that the hard drive is installed properly. This light will blink
during the read/write process. If the light is red, this indicates the hard drive is installed
but failed.
A solid green light indicates that the device is connected to your network properly.
This light will blink during data transfer. If the light is off, this indicates the device is not
connected to your network.
9
10
3
11