Advertisement
Install the I/O Card
See Installing the I/O Card in the Installation Instructions.
Install the Cables
Follow the appropriate instructions in the Installation Instructions for cabling.
Remove the NAM from the 1-Slot Housing
Procedure
1. Disconnect the power cord/
transformer, first from the
power outlet, then from the
rear of the iMarc unit.
2. Disconnect the other cables.
3. Using a small flat-blade
screwdriver, gently pry open
the housing at each of the four
connecting tab points.
4. Remove the cover and lift
the NAM and its integrated
I/O card/backplane (rear
panel) from the base.
5. Lay the NAM on an
electrostatic discharge-
protective work surface,
component side up, with the
card connectors on the left-
hand side.
Install the NAM
See Installing the NAM into a Multislot Housing in the Installation Instructions.
Copyright © 2003 Paradyne Corporation. Printed in U.S.A.
NAM
"
*9128-A2-GN10-20*
2
98-15043a
Integrated
I/O Card/Backplane
Base
98-15044a
Advertisement
