Advertisement
Quick Links
Fitting Guide
Roger and Advanced Bionics sound processors
Naída CI, Auria and Harmony
This guide provides detailed information on how Roger receivers should be used with Advanced Bionics sound processors to
achieve the best possible performance.
A 2013 study by Dr. Jace Wolfe of Hearts for Hearing Foundation, Oklahoma City, revealed that the use of Roger systems in
combination with cochlear implants resulted in significant improvements in speech recognition at high noise levels (70 to 80
dB (A)) over fixed gain FM and Dynamic FM technologies (see www.phonakpro.com)
Set-up
The table below shows what is required to connect the sound processor to a Roger receiver.
Advanced Bionics
2
Naída CI Q70
Roger 17
Roger X is not compatible with the Advanced Bionics (AB) Neptune™ sound processor.
1
Jace Wolfe (2013), Evaluation of speech recognition of cochlear implant recipients using a personal digital adaptive radio frequency system.
Accepted by the
Journal of the American Academy of Audiology.
2
TM
PowerCel
170 battery required.
3
Roger X with SN > 1336NY560 only.
Sound processor
Advanced Bionics
Naída CI
ComPilot + Roger X
Receiver + Adapter
1
.
Advanced Bionics
Harmony™ / Auria™
3
iConnect™ + Roger X
Advertisement
Related Manuals for Phonak Roger 17
Summary of Contents for Phonak Roger 17
- Page 1 Advanced Bionics Advanced Bionics Naída CI Q70 Naída CI Harmony™ / Auria™ Roger 17 ComPilot + Roger X iConnect™ + Roger X Receiver + Adapter Roger X is not compatible with the Advanced Bionics (AB) Neptune™ sound processor. Jace Wolfe (2013), Evaluation of speech recognition of cochlear implant recipients using a personal digital adaptive radio frequency system.
-
Page 2: Getting Started
AB Harmony™ / Auria™ Set the Audio Mixing Ratio (Mic/Aux) to 50/50 For Roger 17, no pre-programming is required. For Roger X when used with ComPilot, no pre-programming is required but might be done to deactivate the AutoConnect tones . -
Page 3: Troubleshooting
Step 4: Test the system Consider testing the user’s speech recognition in quiet with the your patient. Then test the user’s speech recognition through CI alone by muting the Roger microphone and standing close to the Roger microphone while standing at least 3 meters away. Using Roger via the T-Coil Alternatively, the receiver Roger MyLink can be used after activating the T-Coil on the sound processor. - Page 4 Now you can change the gain of the receiver in the range of -8 to +8 dB. Available for Roger 17 (02) and Roger X (02) only Fitting Guide | Roger and Advanced Bionics sound processors Naída CI, Auria and Harmony...