Sanyo DP26670 Owner's Manual page 37

To connect the TV to a PC (Personal Computer)
NOTE: Before connecting any cables, disconnect
the AC Power Cords of both the TV and Personal
Computer from the AC outlets.
1
Connect an RGB cable from the monitor output (a)
on your PC to the RGB connector on the TV and
tighten the screws. (Monitor Cable not supplied.)
NOTE:
If Computer has only DVI Output (b), a DVI to RGB
converter will be required (converter not included).
2
Insert one end of a Stereo Mini-Audio cable into
the PC Audio Out jack and the other end into the
TV PC/HDMI AUDIO Input jack. (Stereo Mini-
Audio Cable not supplied.)
HINT:
Volume can be adjusted both from the PC and the TV
VOL +/–.
3
Press the INPUT SELECT on your Remote
Control to step through signal inputs to select PC.
4
Press the SETUP/TV MENU to display the TV's
PC Setup Menu. Select Auto Adjustment.
NOTE:
Power on the TV and any other peripheral
equipment before powering on the computer.
NOTE:
• Save and close all documents, in case computer might need to be restarted.
• Before connecting your computer to your TV, please refer to the following chart to set to a compatible
resolution.
• A Refresh Rate value of 60 Hz on your computer is recommended for your TV.
RESOLUTION
640 x 480
720 x 400
800 x 600
1024 x 768
1280 x 768
1280 x 720
1360 x 768
54H0521A_eng.indd 37 54H0521A_eng.indd 37
Connections to other equipment
ASPECT RATIO REFRESH RATE
(Hz)
4:3
18:10
4:3
4:3
15:9
16:9
16:9
(a) (b)
RGB
DVI JACK
Rear of the unit
VGA cable (not supplied)
Audio cord (not supplied)
HORIZONTAL
FREQUENCY
(kHz)
60 31.47
72 37.86
75 37.50
70 31.47
56 35.16
60 37.88
72 48.08
75 46.88
60 48.36
60 47.78
60 45.00
60 47.71
VERTICAL
FREQUENCY (Hz)
59.94
72.81
75.00
70.00
56.25
60.32
72.19
75.00
60.00
59.87
60.00
60.00
37
3/17/10 4:28:08 PM 3/17/10 4:28:08 PM