Table of Contents
Advertisement
Troubleshooting
Your stainless system is automatic in normal use and requires only annual servicing. You should
employ a competent installer to perform the annual servicing. Normally this is timed to coincide with
the annual boiler service.
If water is flowing from the safety valves through the tundish this indicates a fault
condition and action is needed.
If this water is hot, turn the boiler and / or the immersion heater off. Do not turn off the water until
the discharge runs cool. The discharge may also stop.
CALL OUT A COMPETENT PLUMBER TO SERVICE THE UNIT.
Tell them you have a fault on an unvented cylinder. We stock all the spare parts they may need and
BSS can be contacted via telephone numbers on back page of the manual.
42
www.bssindustrial.co.uk
Advertisement
Table of Contents
