Table of Contents
Advertisement
Taking The Cylinder Out Of Use
Shutting Down
•
Ensure the cold water supply is isolated and at least two hot water draw off points are open
prior to draining the cylinder.
•
One of the hot water draw off points should be as close as possible to the height of cylinder in
draw off terms.
•
Where applicable use the drain valve at the cold water inlet to drain the contents of the cylinder.
•
Isolate the coil from the main heating system. If necessary blow out the coil prior to moving the
cylinder.
Recycling And Disposal
The cylinder or any of its components must not be disposed of in domestic rubbish. The material in
the cylinder, packaging and components contain recyclable materials and they should be disposed
of properly and in accordance with national regulations.
Guidance In The Event Of A Problem
In the event of a problem please contact your installer and the contact details in this installation manual.
Log Book
The installer must comply with all of the installation instructions contained within this installation
manual. On completion of the initial installation and after each subsequent annual service the
Benchmark Log Book must be completed and signed by the competent person who has worked
the unit.
The purpose of Benchmark is to ensure that customers have the correct equipment for their
requirements installed in accordance with the manufacturer's installation instructions. The equipment
must be installed by installers who have completed an accredited competent person's scheme
and who install, commission and service the equipment in accordance with the manufacturer's
instructions.
All installations must comply with the appropriate Building Regulations and the Benchmark Log
Book should be provide to the customer. The Benchmark Log Book can also be used to show that
all equipment is installed in accordance with the relevant Building Regulations.
Boss Direct / Indirect Installation Guide
41
Advertisement
Table of Contents
