Advertisement
6. Peg down the AIR Break Pro,
start from the ends closest to the
awning then continue to peg each
corner down (see Image 5).
7.
Clip on and peg out the external
guy lines (see Image 6).
8. If you are using the AIR Break Pro
freestanding, clip guy lines onto
both sides and peg down to
secure its position.
Take Down
1.
Deflate by turning the taps on the
grey deflation valves located at
each end of the AIR Break Pro
(see Image 7).
2. Unpeg all pegging points and
unclip all guy lines.
3. Fold and roll towards open
deflation valves, forcing any
remaining air out.
4. Roll the AIR Break Pro into the
carry bag, zip up and tighten the
compression straps.
Kampa UK Limited accept no liability for any form of consequential loss whatsoever. Any sizes and specifications quoted are approximate and are
given as an indication only. Kampa UK Limited reserves the right to alter specifications as considered necessary and without notice.
5
6
7
www.kampa.co.uk
© 2018 Kampa UK Limited, Witham, CM8 3EU
AIRBREAKPRO-UM-10-18
Advertisement
