CAMERA PROGRAMMING -‐ CUSTOM (CONT)
RESOLUTION – (MED default) : This setting is used to determine the megapixel resolution of each
image taken by the camera. This is only for PHOTO mode. With this option blinking, use the UP or
DOWN arrow key to cycle between the options. The higher the resolution of an image the more
space the file will take on the SD memory card. Press the ENTER button to accept all your changes
and to go back to main options menu.
DELAY – (5 SEC default) : This setting is used to determine the length of time that the camera will
wait before it reinitializes its PIR sensor for the next activation. With this option blinking, use of
the UP and DOWN arrows to choice how many seconds you want the delay to be set for 120S /
60S / 30S / 15S / 10S / 5S. Once this setting is on the appropriate time, press the ENTER button to
accept all your changes and to go back to main options menu.
BLUR – (ADV): This setting is used to determine the exposure setting of the camera. On ADV
(Advance) the camera will have a shorter (faster) exposure allowing for a sharper image. While in STD
(Standard) the camera will have a longer (slower) exposure allowing for a brighter image.
BURST – (1P default) : This setting is used to determine the number of photos the camera will take
during its activation. This setting can be changed between 1 PHOTO up to 6 PHOTOS. With this
option blinking, use the UP or DOWN arrow key to move between the value range in increments of
1. Press the ENTER button to accept all your changes and to go back to main options menu.
VIDEO LENGTH – (15 SEC default) : This setting is used to determine the length of time, in seconds,
of the video recording. This setting can be set to 5 - 30 seconds in 5 second increments. With this
option blinking, use the UP or DOWN arrow key to make your selection. Press the ENTER button to
accept all your changes and to go back to main options menu.
10
www.stealthcam.com
Page
877-‐269-‐8490