Sanyo PLC-XW56 Owner's Manual page 46

Setting
Power management
F o r r e d u c i n g p o w e r c o n s u m p t i o n a s w e l l a s
maintaining the lamp life, the Power management
function turns off the projection lamp when the
projector is not used for a certain period.
When the input signal is interrupted and no button is
pressed for more than 30 seconds, the timer display
with "No signal" appears. The countdown starts to turn
off the lamp.
Select one of the operations:
Ready. . . . . . . . When the lamp has been fully
Shut down . . . . When the lamp has been fully
Off . . . . . . . . . . Power management function is off.
Then set the countdown timer with the Point
buttons.
 Note:
Factory default is "Ready: 5 min."
46
cooled down, the POWER indicator
changes to green blinking. In
this condition, the projection lamp
is turned on if the input signal is
reconnected or any button on the
top control or remote control is
pressed.
cooled down, the power is turned
off.
Power management
Time left before Lamp is off.
◄►
Press the SELECT button
at Power management
and this box appears.
Choose one of three
settings with the Point◄
►buttons, and go to the
timer with the Point
▲▼
buttons and set time with
the Point buttons.
◄►