Sanyo PLC-XK2600 Owner's Manual page 50

Setting
Standby mode
This function is available when operating the projector
via network.
Network .... Supply the power to the network function
even after turning off the projector by
pressing the ON/STAND-BY button on
the remote control. You can turn on/off
the projector via network, modify network
environment, and receive an e-mail about
projector status while the projector is
powered off.
Eco ............ Select Eco when you do not use the
projector via network. The projector's
network function will stop when turning
off the projector, you can not turn on the
projector via network.
Refer to the owner's manual of "Network Set-up and
Operation".
Note:

• When selecting Network, the cooling
fans may be running depending on the
temperature inside the projector even if the
projector is turned off.
• When Eco mode is selected and the projector
is in Stand-by, the communication of RS-
3C serial port is not available.
P-timer
This function allows you to change the setting of the P-
timer and execute it.
Select one of the following options:
Count up . .......... The P-timer display 000:00 appears
on the screen and the count starts
(000:00–180:00)
Count down . ..... The time set in the Timer setting
appears on the screen and the
countdown starts.
Timer . ................ Use the Point ▲▼ buttons to set the
Timer (1–180 Min). Timer is available
in Count down only. Factory default
velue is 10 Min.
Start .................. It executes the count up or count
down function. Press the SELECT
button at Start and the indication
changes into Stop. To stop Count
up or Count down, press the
SELECT button at Stop on the screen
menu,then the indication changes into
Restart. Press the SELECT button
at Restart to resume Count up or
Count down.
Reset . ................ Reset the P-timer values.
Press the SELECT button at Reset to
return to the following value;
Count up ... "000:00"
Count down ... Timer that you set
Exit .................... To exit the P-timer operation.
50
X: disabled O: enabled
Serial command
Network
Monitor Out
Audio Out
Direct on
*1 When switch the Standby MIC out function On and in
Standby mode status, only MIC volume can be output.
P-TIMER
0
P-timer display
Stop or Cancel the P-timer via Remote Control
To stop the P-timer function, press the P-TIMER button.
To cancel the P-timer, press and hold the P-TIMER
button for a few seconds.
*1