aci /DP Series Installation And Operation Instructions

aci /DP Series Installation And Operation Instructions

Low differential pressure transmitters

Advertisement

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ACI/DP Series and is the answer not in the manual?

Questions and answers

Summary of Contents for aci ACI/DP Series

  • Page 3 1/4” push-on. To achieve the shortest response times, larger diameter tubing can be used on long tubing runs. All ACI/DP units can handle a maximum pressure of 5 times the sensor range on the High side and 3 times the sensor range on the Low side.
  • Page 4 SELECTING ANOTHER SPAN Each uni-directional ACI/DP unit has the capability of being switched to three spans other than the span ordered. The bi-directional units have only two span capabilities. The switch to other spans is achieved by changing the position of jumpers found inside the enclosure. After opening the enclosure, there will be two sets of jumpers. One is a double row of pins (J4) with four positions numbered 1 through 4.

This manual is also suitable for:

Dp2

Table of Contents